@lordvampire
Discovery Tonearm Cable is great and not so expensive, for Technics tonearm you need 25cm, but it’s not easy to find, this cable is 4 wire (4 colour) is sold by the foot. You can buy from
partsconnexion.com in Canada. I don’t know any other seller who can provide it. Discovery wire is more flexible than Cardas Tonearm Wire, which is widely available and a bit cheaper, but also good option for resonable price. If you want Cardas buy it from thebetteraudiocompany on ebay, they can also custom made headshell lead wires with pins for you from the same Cardas cable. My pair of 1210mk2 rewired with Cardas internally, but my external RCA phono cable is Zu Audio Mission. The 1210mk is not my main turntable, but it was fully upgraded long time ago, before i bought Sp10mk2.
I just ordered Discovery tonearm wire for my Lustre GST-801 tonearm as i wanted something better than Cardas. Another option is Audio Note silver tonearm wire, but this is very expensive.
Personally i don’t care about resonance frequency anymore: 8Hz or 10Hz or 11Hz it doesn’t really matter and anything from 7 to 12Hz is fine, you will not hear the difference!
Most of the MC cartridges are low or mid compliance, while the MM can be mid, high or very high compliance. Your technics was designed for MM cartridges, but mid compliance MC are OK to use too.
Headshell and screws should be non magnetic - that’s all.
The weight of the shell depends on the compliance of the cartridge, the lower the compliance the heavier headshell required on this arm. But when it’s too heavy it will be impossible to balance the tonearm even with small additional counterweight. This tonearm is not designed for heavy cartridge/headshell combination!
I don’t think you are hearing the power supply, the lower the signal on your MC the better shielded phono cable you need. In real life you will never use maximum gain. This is not a high-end turntable anyway, especially with MC cartridge, try it with MM instead for noise problem. I can’t remember any noise problems with MMs i’ve tried on my 1210mk2. I would never invest money for external power supply for this deck, it’s much better to buy another turntable if you want to know what technics is all about (try SP10mk2 with EPA-100 tonearm).
Look for SAEC SS-300 matt - this is the best!