Fuse and Power Cable improvements 'how'? - Nuprime ID-8

alpha_gt
I don’t think power cables or fuses will achieve the results you are looking for. Most people who enjoy improvements with these upgrades are in measures of resolution. More air around instruments, more precise soundstage. They are not going to increase the sense of power or bass slam.

I’d opine resolution per se is probably not the overriding issue for most audiophiles, so your post is a little bit of a Strawman. I’d further opine the sonic characteristics competing with resolution are treble accuracy, overall tonality, low distortion, frequency extension, bass performance, musicality. In addition AIR is most likely a combination of resolution, high frequency extension and low distortion. What makes your statement perhaps even more of a strawman argument is the fact that many of us actually do achieve greater resolution, sense of power and bass slam with aftermarket fuses and audiophile power cords.

Geoffkait, point taken. But unless your previous power cord was completely too small, I doubt it will make a measurable increase in current flow. While two 10gauge cables may sound different, they both flow the same amount of current. If his amp is running out of power, no amount of clean power is going to change the architecture of the amp. Don't get me wrong, clean power can make worlds of difference in the quality of sound, even perceived bass slam, but not in the order of magnitude to suddenly make that amp a great match for those speakers. In fact, these are measures that should be done anyway, to get the best from any amp he may own. If these upgrades could actually increase the watts produced and current flow, then the manufacturers would be doing it at the factory to bolster their specs. No amount of fuses and cables can make a 200 watt amp into a 250 watt amp, simple as that. If that is not relavent to the OP's question, then what is?

in my own experience I touched on in my last post, I tried all manner of tweak to try and get my amp to perform. Power cable, fuse, speaker wires, and finally a second amp to drive the lower half, while I noticed improvements with each tweak, nothing suddenly made that amp a good match for these speakers. It was just too small, you can't make a silk purse out of a sow's ear. 

@alpha_gt - while I agree that two different 10awg cables will still be able to flow the same amount of current, one thing that is not looked at here is how fast the amp is able to pull that current from the A/C line.  In my testing with power cord connectors, I can completely change the sonic character of the sound just by using different power cord terminations.  A very good example here is comparing gold plated to rhodium plated terminations.  I have found that the rhodium plated power cord connectors ultimately give the best sound.  The bass is very tight, punchy, and powerful.  Mids/highs are very clear and clean.  When you switch to gold-plated connectors on the same power cord, the sound becomes more laid back.  The bass becomes more loose in a sense and loses the punch/tightness/detail.  There is still a full amount of bass (which means the amp is getting the large amount of current), but in a way the slew rate of the waveforms are somewhat slowed down because the gold-plating is giving you a more gradual power transfer.  The Rhodium plating will give a more immediate power transfer (in my opinion).  The contact materials matter when you have two elements mating to make a power circuit.