Can you bridge a carver 705x 5-channel amp ?

carver gear has it's own forum & would probably be the best place to post your question,here is a link to the forum.

hopefully somebody there has an answer for you.

{http://www.carveraudio.com/phpBB2/index.php}

IF you have the amp or can look at it, you should be able to tell on the back panel. There is often a switch and or pictoral instructions for bridging the amp if it's possible.

BTW, if the amp is bridgable, it would probably put out more than 250 wpc. When bridged, the wpc rating is normally twice the 4 ohm output power.

be careful, you might not be able to run 4ohm speakers in bridge mode.