Duelund DCA16GA

I have Duelund 16 GA as speaker cables for my Analysis Audio Epsilon and Air Tight ATM3. (1,5m)
DCA16 GA inter connect between Pre and amps 2.0 m)
DCA 20 GA interconnects between pre and  DAC (2.0 m)
DCA 20 GA betwenn Step up and pre (1.0m) shielded by Chris at Paers Connexion. It has been longer to burn in to and take some relative brilliance off.
Next step is to intervert 16 GA for the 20 in the pre to amp circuit.

I Pre ordered the 12 from Part Connexion for the speakers as I am curious. I will see what it brings to the table.

When I am sure of all that I think my quest for cables will be over. 

I am using the Duelund 16ga on the high pass portion of my AZ Crescendo speakers. I was using the WE 10 ga as my sole cable on my biwire speakers. I kept the WE10 on the bass and now have the Duelund 16ga on the highs. Much more detail for sure. Not sure if it is too aggressive however? Only 12 hours of burn in however? Not sure if it smooths out over more hours. We will see. A little too much of a good thing thus far in my system and to my ears.

On great recordings I love the Duelund, but on less than great it is a little harsh for me.

I forgot got to mention I also used the Duelund 16 as jumpers up to my highs. I liked it better than the WE 10ga alone. Thus far it is smoother than the Duelund 16ga run from my amp to the highs. I hope the Duelund wire mellows out with break in. If it does, it will be perfect.

My Duelund 20ga (un-shielded) is now being terminated by a local tech who is also a manufacturer of boutique electronics. My pair is being terminated with Switch Craft RCA's. If I like this interconnect, I may do the same, but this time shielded. So far I have been very impressed with the Duelund 16ga as speaker cable, but on a second system with a digital source.
grannyring- interesting observation. Sounds as if it's quite neutral, and it's exposing less than perfect recordings for what they are. I listen to my share of not so great recordings, so that may not be a good thing. I also plan to try the 16ga from my Jagusch crossovers to my Altec Valencia's. This will take the place of Belden 9497 for comparison sake.

Thus far I prefer the Western Electric 10 gauge wire over the Duelund 16 ga for speaker wire. The WE is far  more full bodied and easy sounding. The Duelund is just a tad to thin sounding and too alive for my system. This is after 20 hours of burn in on the Duelund however. I just don’t think it will change enough however to compete with what I like about the WE 10 gauge wire.

Now the Duelund 16 ga makes a wonderful IC......very good in this position!