Eminent Technology ET-2 Tonearm Owners

John,
I'll probably end up getting the aluminum base sooner or later.  Right now I've been tweaking and upgrading for over two months and have it where I'm very pleased with the result.  So for a while I'm going to subscribe to "if it ain't broke don't fix it."

Chris,
Nice down here in the lower colonies too.  Gonna have to plow the garden soon.  Audio passion?  How polite......Actually, I'm just retired and OC.  The best description I can give to where the system is now is while I'm trying to listen to the system to make sure the setup is correct I find myself listening to the music instead.
May you all have spot on VTA,
Harry

A lot of passion, indeed; and, I am impressed at the fine level of nuance that you are able to hear and able to describe.  Harry, no shame due for wondering if raising the arm board might be a step backwards in transparency; it's always a possibility that would be hopefully offset by the gains from proper VTA adjustability. Sometimes we have to give up a little somewhere to gain something more important elsewhere.  Glad to hear you don't think you've had to give anything up and the magic is back.  I did have a thought about something that I am surprised we all overlooked (I think) when discussing your VTA issues.  The HW19 MkIV platter itself can be raised or lowered by turning the bearing's thrust plate.  When I had the MKIV I had the platter just barely clearing the table's top plate.  How much clearance do you have?  Lowering the platter may get you some more (or easier) VTA adjustability.  Btw, the extra armboard will go out this morning; had to get through a very busy weekend.  Let us know how it all works out. 

Hey Harry,
I'm happy as well that you're enjoying the arm. By the way what loading are you using on the Lyra Delos cartridge? I'm at 100 ohms with the Lyra Kleos, but using some pretty low capacitance pure silver interconnect (old AQ diamond X2) from the junction box to my phono preamp ( total capacitance 60 pf using Bruce's standard harness). -Lyra states their cartridges don't do well with high capacitance cable. So. I'm trying to keep it as low as possible. At 100 ohms, the base is incredible and vibes come thru perfectly.
Regards,
John

Hi Frogman,
Guess I didn't know the platter height was adjustable.  I'm about 1/4 inch + above the plinth.  It would have been interesting to try.  Not possible now unless I lower the arm board because my platter extends just a hair over the arm board and the clearance there is very small.  I must confess while I've read about bearings and thrust plates for years related to TT maintenance, I'm not sure I know what the thrust plate is or how to adjust it.  Good lord, not something else to adjust?!

I too am rather surprised at what I can hear.  I'm 73 and spent 5 years as a Naval Flight Officer so I do have some hearing loss.  I doubt I have anything left above 8-9k hz.  That said, I can hear room, air and low level detail on well done recordings.  Guess it is the harmonics.  I suspect my hearing loss contributes to the difficulty I have with VTA adjustment.  I think sometimes in search of the higher frequencies I tend to push the cartridge nose down too much.  But I'm learning.
Cheers,
Harry

Hi John,
I'm using 1 ft long pure silver unshielded, cotton insulated interconnect from junction box to my CAT SL-1 which  is supposed to be 47k ohm.  The IC is made by a fellow in Texas and is sold only on eBay.  I don't know it's capacitance.  It should be pretty low.
Cheers, 
Harry