VPI Analogue Drive System

jerry95

... I was thinking along the lines of ramping the speed up or down in tiny increments to see how it might affect individual recordings which may too "bright" or too "dull". I listen to classical music exclusively and many digital recordings sound "digital", just like CD's.
Has anyone experimented along these lines, to make these recordings sound "better"?

I don't think adjusting turntable playback speed is a remedy to treat bright or dull sound.

cleeds,  Do you dispute what I actually wrote, in essence, that you can set platter speed with the SDS or the Walker?  I did neglect to mention that the motor should be of the AC synchronous type, but that wasn't really the question.  Most turntable motors fit this category, to one degree or another. Also, I don't know how you can say that current has no effect on platter speed, but frequency does.  "Current" has the property of frequency, which as you say does determine the speed of an AC synchronous motor.  I have read conflicting statements about the degree to which AC line frequency is tightly or not tightly controlled by power companies. Most sources say it's "pretty good" with small variations over short time that average out to 60 Hz over longer time periods.  Is that good enough for most audiophiles? I don't think so.

Jerry, Stylus drag is definitely NOT constant, by the way.  It's constantly varying across the surface of an LP.

I moved my motor drive belt up to the top slot on the motor drive pulley which effectively lowered my 3150 test tone from 3160 to 3149 on my PlatterSpeed app.  There was a significant improvement in sound quality with all my MC cartridges (I have 4 of them).  This obviously didn't cost me anything and I should probably have done it awhile ago, but I've just started paying attention to this tweak.  So far I'm not running out to buy anything yet.

Running your TT at the right speed (or nearly so) is not a tweak.  It's just a very basic thing everyone should do, like leveling the platter.

Melm:

Sorry.  Wrong word.  At this point I'm almost ready to take your advice not to buy anything and maybe the DIY components that Phoenix Engineering used to make will be available again.
So far no one who has bought the ADS has responded as to how great it is.