Has anyone listened to Legacy speakers?

Lak and Tubeears, what kind of music do you listen to? What volume levels? What size is your listening room? I own Classics, my room size is 14 x 22 x8.5 and opens into an adjoining room. I listen to rock, blues, jazz, folk, new age, classical, pretty much anything but country or rap. I would say at moderate to high levels. I think 200 watts a channel to be the minimum I would recommend. Now I haven't used tube amps and rumor has it they play louder than their ratings, but with solid state I think them big drivers need a high current amp to keep them in line. When I've tried lower powered solid state amps, I can hear them strain and the bass gets looser, more bloated, IMHO. I use Classe amps, that's about as warm as solid state gets. I think tubes would sound great, but I don't know if they would get the woofers to snap to attention like the high powered amps I've tried. I think about trying tubes, but I would say about 60% of my listening is rock and I need to feel the power. I believe the tubes would make the folk, jazz or classical sound better, but I think the 200 wpc Classe will beat 'em on rock. What do you think?

The Legacy Convergence crossover. It is very well done.
In terms of quality, structural integrity and/or workmanship the Legacy crossover is as good (or better) than you will ever see in many Hi-End speaker systems. With regard to the construction techniques and material, I have not seen anything that surpasses (at least by any wide margin) the quality of the Legacy crossover (that covers much turf after 35 years of this rabid hobby).
After pulling the top woofer out of the cabinet and removing the absorbing material, I was immediately surprised by the large dimensions and impressed by the obvious high quality of the crossover. Not just on "one" side .. but on "both" sides of the cabinet. Firmly attached by screws and starwashers are two 10" by 10" enamelled layout boards.
The woofer section is attached to the right side and holds three very large coils (about half the size of beer cans). Also mounted on that board are Sprague capacitors and the "star" termination for the Kimber wiring. The left side holds another 10" by 10" enamelled layout board for the mids and highs. There is one large coil, three medium size coils and the capacitor arrays. The capacitors are (once again) Sprague and also (to my amazement) Sidereal (!). Again, the terminations were "star" grouped. Where they were soldered, it was all done with silver solder. All junctions were done on threaded chrome posts with nuts large enough to cover the entire surface area of the forked spades or ring terminals. Quite to the contrary of some other comments (on the material used), I did not find any (not even one) "clip on" style connector (s). Every connection was tight (held either by the binding posts or solder) and had ample clearance from other connections, terminations and componants. All jumpers (where used) were heavy gage, high quality hook up style wire (at least 12/14 ga.).
I did not recognize the brand of coils, so I opted to call Legacy. I was braced for some "one" or some "thing" to advise me to go to Radio Shack and look for my answers there. Not the case. I talked with a real human (Chris) and he was happy to help. He was very professional and pleasant to talk with. He hasn't been following this string of posts on the Audiogon Discussion Forum, but I suspect that he will. He stated that Legacy made their own coils and that they are tuned to very close tolerance. He seemed very proud of their exceptional quality and performance. I must agree. The quality is obvious ... that was the reason that I broke into these things. Chris stated that they do not use Kimber for their wiring anymore. Too bad. If nothing else it (the Kimber) looks impressive inside the box. They do (according to Chris) use an OFC, heavy gage stranded cable (at this point in time). The Legacy is, without a doubt, a sonic "world class" performer and is outstanding in it's use of material, design technique and workmanship. Perhaps the word work"women"ship should apply here. It is "Gladys" that builds (and supervises the building of) the crossover boards (although mine is signed by a former employee, "Connie", Gladys quite probably had a hand in it as well). I do like that kind of "personal" flavor. It seems odd to spend thousands for a speaker and not know who built it. Strange that audio is coming to that. Music, it's instruments and its makers are about art and personality (aren't they ?). Anyway ..... I hope that this information helps those that are looking to find a few answers. I am (imho) very impressed with Legacy (at least the ones that I have). The "boom and sizzle" comments along with the "cheap crate full of bad parts" rumor is just very wishful thinking for Legacy's competitors. These are fine instruments of artistic value, inside and out.

Tubby .......

Tubeears, thanks for the information. I’m sure it took you a while to research and write. Good informative job!

Jmcgrogan2, I basically agree with what you say. I listen to jazz, big band, pop rock, female vocals blues Latin, rock, classic etc. The music room I use tubes in is 12 X 15 X 8. The solid state unit is in the great room 20 X 18 X 8 which opens into the kitchen 23 X 14 X 8.

Tubeears,great job reporting the crossover. I'm not at all surprised with your findings. All my experience with Legacy has been positive. I have had my classics for 5 yrs. to all who responded about the high power amps ..thanks! Maybe one day I'll upgrade from my bryston b60.

Thank's everyone for your support on this fun journey into LegacyLand. (jmcgrogan2) My listening area is my living room. It is 15 x 20 x 8.5. The speakers are set at an angle along the "long" wall. They are spaced 7 ft apart and the angled distance from the wall is: (measured at the corners of the front edges) 49 inches on the outside edge and 43 1/2 inches on the inside edge.
I listen to just about all kinds of music. I like to have the system going at all times. My front end is a Rega Planet and a Sonographe SG-3 table. I am indeed fortunate that my partner in all of this is my wife. She loves music and keeps me on my toes if something does not "sound" quite right. I am older than dirt, and was raised with tubes and "monophonic". Back to the Legacy's. The power required for them seems to be a fairly moot issue. The quality of that power is an issue. The 50 watt Kora (that my friend brought by) was just stunning in its performance when mated with the Legacy's. It is a Tube unit. I use (at this time) a very musical and semi-powerful amp that is very "tube-like" in sound. It is the B&K ST-1400 Series II. With my Classic's I had (at the time) a Sim 4070se and a McCormack DNA 0.5 Deluxe. I was not pleased with either of these amps with the Classics. The amps were, however, superb when mated with other speakers. I was very impressed with the Sims detail at "low" levels and the McCormack was sweet and open (albeit a bit dry). I would like to try an amp with these that is not longer made. It is a N.E.W. DCA-33. I have heard this amp on a few occasions and it is just superb in it's control of the low end. It is 33 watts but sounds like 330. I have heard it with a verity of speaker and it is very solid and musical in it's presentation. If anyone has any experiance already with the Legacy/N.E.W. combo, please let me know you thoughs on it.

Tubby