Intigrated Amp Dilemma

It sounds like the OP already has an in-depth knowledge and experience in the audio gear so I'm not sure exactly what type of input he's looking for. That said, if it were me, I would not necessarily look for more wattage as most (other experts) have pointed out. I would either look for an integrated that can double the power as the impedance is halved, e.g., Ayre, Pass, etc., or the MA7900-like unit I'd mentioned earlier with autoformers. Hope this helps.

Well Stereo5, as long as the volume level you’ve described is accurate at 93-95 decibles, and as long as your speakers are working correctly, then it’s simple math. You may have been in the hobby for 45 years, but if you can’t understand the basic concept that I laid out, then you have more to learn.

Your speakers will produce 91 decibels at one meter distance with one watt. It’s just simple science. So depending on how many meters back from the speakers you sit, and how you measured the volume level of 93-95 decibels(or were you guessing?), the Parasound amp is putting out 2-8 watts or so per channel. It’s not straining, believe me.

What is possible is that you don’t like the sound of either the Parasound amp, or the speakers, or the result of the combination of the two. But that amp is not straining.

You mentioned having another system, perhaps you could pair your Triton 2 speakers to that amp, and see if you prefer that sound, if you haven’t already. If you like it better than the Parasound, then buy the other brand.

There is nothing wrong with the speakers, I already put the speakers in my main system and they sound fine. 

Sounds partially like a synergy problem to me. You seem to prefer the Rogue sound in your Reference system over the Paradigm sound in your office system. But I also assume your source and such in your office system are not as competent as your main system.

Make sure the sub & pre output switches are turned off if you are not using them. Check the voltage switch on the rear panel to insure that is correct. Then double check to make sure both speakers are wired in phase. If so, reverse the +/- wires at the speaker or amp end whatever is most convenient. If that doesn’t change things, try one out of phase speaker at a time. There is always an outside chance the speaker posts where wired wrong at the factory. I would also try a different set of speaker cables or power cord to see if that changes things.