2. speakers
  3. 131809-4121

Magico S5 Speaker - SET UP ADVICE PLEASE - Tow-In - Etc.

Any Magico Owners or Dealers or Folks or anyone that may have some basic advice, ideas or feedback from hearing or seeing in a friends, dealers system or owned older version of Magico or something like or anything really that can help me? How are yours or theirs set up? The smallest moves makes huge changes and I am coming from speakers that are so very different so any and all feedback would so welcomed.

I CAN EMAIL YOU PICS of Room / Set up / Etc  fsmthjack at YAH00

THANK YOU

BACKGROUND INFO:

ROOM:                         24 x 14 with cathedral ceilings 
MUSIC:                        Good mix - no hard metal / large orchestra and the like
LOUDNESS:                normal levels - just loud enough to sound best
SPEAKERS                  Magico S5 Speakers
AMP:                            Pass Labs X350.5 Amp
SOURCE:                     Bricasti M1SE DAC
TRANSPORT:               mircoRendu 1.4 w/Full suite of Uptone Audio products
CABLES                       HiDiamond Full Loom 
CONDITIONER            HiDiamond HDX2
SUBWOOFERS           (2) Sumiko S.9 Subs (hoping not needed with new Magico's) 

Thanks guys - I am kind of lost here and any help or feedback to get me heading in the right directions would be so appreciated.







128x128Ag insider logo xs@2xfsmithjack
dguitarnut
136 posts
 
I can’t emphasize enough the use of a preamp with the DACs at least in my experience. It was slightly sibilant and thin sounding in my system with my Magico S1 Mk2 in all my direct testing of several DACs with volume control.
I am presently using a Pass Int-60 with a Chord Dave. I have now sold my S1Mk2 and awaiting delivery of S3 Mk2.   I considered like you the S5 and Q3 but my room is 11x14 with 10ft ceilings so I think I’m even pushing the envelope with the S3 Mk2.  I was very happy with the S1 Mk2 but upgradeitis got the best of me.
almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
Fsmithjack, yes, what you said in your last post is correct. And for a typical RCA plug, such as this one (shown with its housing removed) the connection point for the ground shell is easy to distinguish from the one for the center pin once the housing is taken off. In the one shown in that photo it would be the longish part that extends out to the lower left.

Best regards,
-- Al

fsmithjack's avatar
Ag insider logo xs@2x
fsmithjack OP
712 posts
 
So the middle circle is for the signal and the bottom wrap around piece is what i solder it too? The one with the little teeth on it?
Thanks 
almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
Yes.  The black wire would be soldered to the wrap-around piece having the little teeth in it (the part of the plug that is closest to the lower left of the photo I provided).  The small circle that is further forward and is centered in the middle, which in a normal RCA cable would be used for the signal connection, should be left unconnected.

Also, as you most likely already realize, since you are using two subs the red and yellow wires from each sub would BOTH be connected to the amp's positive output terminal for the corresponding channel.  In other words, the red and yellow wires from the sub on the left would connect to the amp's + output terminal for the left channel, and the red and yellow wires from the sub on the right would connect to the amp's + output terminal for the right channel.  The RCA plug to which the black wire from the left sub is connected would plug into the amp's RCA input for the left channel, and the RCA plug to which the black wire from the right sub is connected would plug into the amp's RCA input for the right channel.

Best regards,
-- Al
 
fsmithjack's avatar
Ag insider logo xs@2x
fsmithjack OP
712 posts
 
Thanks - I took all the sub cables for both suns and matched them and spliced them together- red with red - yellow with yellow and black to back and made into one cable and then attached nice Cardas spades so all are one - and nice and easy to hook to speaker terminals - is that ok?
thanks 
More to discover