2. speakers
  3. 1019248887

Would you like to know about Dunlavy mods?

I have done extensive mods to my Dunlavy SCIV's over the years. It has been quite a learning experience in component upgrades such as capacitors, resistors, inductors, internal sealing of the wood of the cabinet, nuts, bolts, internal wiring , external crossover isolation, speaker platorms, Sistrum platforms and baffles to minimize bass cacelation. I suppose that was an example of a run on sentence. If any one would like to know more please contact me.
theaudiotweak
americanflag
39 posts
 
Any updates to this thread?
vn101606
73 posts
 
I have a pair of Dunlavy SC-VI, and I am considering upgrading the binding posts, resistors, capacitors. Probably with Duelund cast copper or silver components and Furutech top binding posts.

Perhaps also bi-amp them using an active crossover like the Krell KBX and a second pair of Krell FPB 750mcx.

Does anyone have the SC-VI crossover schematics and/or high-pass and low-pass filter frequencies?

Thanks!
vn101606
73 posts
 
Hello!

I have pair of Dunlavy SC-VI that I would like to upgrade the binding poles (with top Furutech), crossover capacitors and resistors, and perhaps bi-amp with an Krell KBX crossover.

Does anyone have the crossover schematics of the SC-VI or at least the low pass and high pass frequencies?

Thanks!
615098's avatar
615098
1 posts
 
Hey - I just decided to raise my Dunlavy SC-IV/a by adding the supplied bases, but have lost the original bolts. Does anyone know the size/metric/US, etc?

Im going crazy going back and forth to the hardware store. 

Thanks, 
Derek

timber77
39 posts
 
I tried to lift  up my sc 4s  and help you out on the screw size ,but they are too heavy for a one man job.   I would get 8 of every screw size thats close and return the rest.. i think mine were about 3 inches long, but is been many years since i moved them.   Good luck and the bases with probably help tighten up the low end.

More to discover