2. analog
  3. 131646-1659

What direction is VPI headed?

First let me state that I own a VPI Prime w/perifial ring, SDS, and a couple extra arm wands so I have invested some $ overall, this being my third VPI table, with that said I am a happy VPI customer but here recently have taken a few notes on their constantly coming up with the next iteration of what ever is moving well and I do believe the Prime is one of those. When they came out with the Prime Signature it was hard not to sell and replace with it but I didn't now the Prime Signature Rosewood is gorgeous but at $6,800.00, now when you get to that cost level I started looking used and have seen the prices dropping ridiculously low on a couple of HRX setups with all the extras for  a lot less than that and they still aren't moving. I know there are those that speak of VPIs marketing from time to time but what is going on.
tooblue
testpilot
952 posts
 
@vpi the HW-19’s motor replacement can be sourced from Hurst and any competent acrylic manufacture can manufacture an arm board without breaking a sweat.  When a product has been out of production for closing in on 20 years, a manufacture must cut the umbilical cord and the legacy owner must become less dependent and more resourceful.  
bdp24's avatar
bdp24
9,846 posts
 
What have ya'll found to be an improvement over the stock isolation springs in the HW-19 (all iterations)? Herbie's dots, SIMS Navcom Silencers, Sorbothane spheres, cones, anything DIY, etc.
mofimadness's avatar
mofimadness
4,993 posts
 
What have ya’ll found to be an improvement over the stock isolation springs in the HW-19 (all iterations)? Herbie’s dots, SIMS Navcom Silencers, Sorbothane spheres, cones, anything DIY, etc.
I have tried just about everything.

My favorite are the SIMS Navcom Silencers, (with the bands removed). Unfortunately, they are getting really hard to find.

YMMV
bdp24's avatar
bdp24
9,846 posts
 
Thanks mofi, I happen to have a set of SIMS left. I'll give them a try, as well as a set of roller bearings that I neglected to include, though they don't isolate vertically. Maybe even the Townshend Seismic Pods!
slaw's avatar
slaw
21,747 posts
 
@bdp24,

I lived with mine for over 20 years with my ET arm and tried several things.
It has a very resonant base that is difficult to overcome. It is a tweekers tt though. I’ve used the SIMS, practice golf balls, etc... In my experience, anything rubbery/squishy became a trap that destroys ultimate dynamics, transparency and bass response. ( I believe this to be a general rule of thumb. The 1st thing I did when I bought my Classic 3 Sig SE was to replace the rubber (inside) feet with Stillpoints SS). I was never happy until I ended up using a stack of Symposium Rollerblock Jrs. w/ ceramic ball bearings, that I had to modify the base for their use.
More to discover