me again. i am suffering from the mid sixties disease CRS. I realized i have posted here before so my first statement above was not correct.
- ...
- 13446 posts total
jut in case someone needs this info thought i would post it. Hi Kent,
I have examined the CS2.7 coax that you returned. The failure mode was a buzz generated by the midrange cone. Upon closer inspection I found one of the joints between the diaphragm and the coil former was broken or loose. This will definitely be covered by your warranty, and you can disregard the memo bill sent. Thank you for your business.
Best regards and Happy Listening!
Rob
Rob
Gillum | Service
Manager |
Prof, 'I had a $999 sniping bid in, set to hit 4 sec before the auction of the SI1 sub integrator ended. I don't like bidding early and bidding prices up. i called and asked Rob about it. He suggested that the px02 and px05, with the correct chips which they're running out of, match the Sub introduction perfectly to where Thiel's start to drop off (around 38 hz for the 2.4 and 2.7 as the woofers are the same). Rob said Jim Thiel built and sold only a few hundred integrators at most, and some have come back for repairs that can't be done. Some failures are obvious as in lights not matching settings and some must be listened for. Since I have the px02 configured by Rob for my 2.4s I decided to pass. If I were trying to match non-Thiels to the smartsub, I'd have taken the chance. another thing to know about the SS1 and 2 is that Thiel has no replacement amplifiers. A year ago they were going to develop a new sub with a compatible amp but that didn't happen. if I had to start from scratch, I might look at REL. Are we going to have to start a Go Fund Me to keep Rob and the service department open? He's only 55 so could provide many of us service as long as we need. Bob |
- 13446 posts total