Duelund DCA16GA


Hi All,

I was wondering if anyone have try this cable? I have never try the original WE cable but I want to buy this cable for my speaker. Other candidate is supra cable.

Can someone give some feedback?

Thanks
santodx5
Mitch2 & Grannyring; I am settled right now with a combination of both of you recommendations.  I am using Bi wire 10 awg Western electric with no connectors(bare wire). Surprisingly in my system, the single wire sounded with less highs and little less defined low ended; everything changed with the biwire, better highs, clear low end, more dynamic and of of course the famous nice midrange that this cables are famous for.  Thanks a lot for your inputs. Cheers,
I NEED GUD SOUND ADVICE                                                                    SETUP.                                                                                                          BP9080X TOWER. BP8060 TOWERS REAR SURROUND.ALL DEF TECH                   4 HEIGHT SPEAKERS IN FRONT 2 DOLBY ATMOS 2 SR9080 DEF TECH surround  & 2REAR SR9080 SURROUND                EMOTIVA. XPA9 GEN 3 AMP.W/XLR OUTS.                                             SR8802A PREAMP MARANTZ                                                                   WITH BASIC BEST BUY SPEAKER WIRE CAN I IMPROVE SOUND QUALITY WITH SPEAKER WIRE & XLR CABLES. UPGRADES WILL I TELL THE DIFFERENCE I'M READING ALOT OF AUDIO FORUMS THIS STUFF COST WHATS A GUD WIRE & CABLE BUDGET FOR WHAT I HAVE THXS AUDIO COMMUNITY
                                                                 
I just made two sets of 3.5M long balanced interconnects using the same construction method of a twisted pair of conductors encased in a noise-reduction braided tube as a spacer, then a tinned-copper braid shield connected at only the source end and then a counter-spiraled ground wire outside the shield and connected at both ends, with the whole thing covered in clean-cut TechFlex.  Both sets were made with Furutech FP-601/602(G) connectors.

The difference between the two sets of ICs was the wire used.  One of the sets was made from Duelund 20 awg tinned copper wire with a 18 awg ground wire and the other set was made from WE 16 awg tinned copper wire with a 14 awg ground wire.  

The difference between the two cables is interesting.  I like them both and would choose either in comparison to a pair of the same length of high quality Furutech u-P2.1 PCOCC 19 awg interconnects I own.  The Duelund 20 awg cables have nice tone and good dynamics.  The larger 16 awg WE wire cables have an even fuller tone and a bold, powerful sound.  The Duelund ICs do a bit more/better with the upper frequencies but I like what the larger WE wire does for bass and midrange.  The WE cables are not as burned in as the Duelunds, which spent 4 days on the Cable Cooker and then a day in my system.  I will burn both sets in more and report back.  I am very close to having my entire system wired with the WE (or Duelund) wire, including ICs, SCs, and PCs (but not my USB cables).
I am building usb cables with the Duelund 20 ga this week and will report back. Also building a usb cable using Mundorf silver and gold wire.  
IS DUELUND DCA 16AWG BETTER THAN AQ TYPE 4 & KIMBER KABLE 8TC THXS I’M INTERESTED. IN THE DCA 16AWG MY TOWERS R 92db