2. cables
  3. 133060-154

Simple copper speaker terminal jumpers? Lost my originals.

Can anybody recommend simple, but good quality, copper jumpers that bridge the bi-wire terminals?  I mean just the little piece of copper with the openings on each end.  I see the Cardas ones, but I don't understand how you can adjust them for the distance between the terminals, as they seem to be a solid piece.  Can they be bent a bit to make them fit?  Any other suggestions? 

The reason I'm asking is that I seem to have misplaced the original jumpers for my speakers and I found a set lying around the house that seem to have been from different speakers and don't really fit completely onto the terminal posts.  Also, they look more like brass than copper.  So, I'd like to try a different jumper.

Also, I currently have the cables connected to the HF terminals, but I saw on some threads here that people were connecting the cables to the LF terminals and jumping to the HF.  Which do you think is better, audio-wise? 
mtrot
mtrot OP
804 posts
 
Thanks, all.  I'm going to call Legacy Audio and see if they have any jumpers that will fit the posts on my speakers.

The only reason I'm concerned about my current jumpers is that, as I said above, the binding posts are too large diameter for the jumpers to fit over them, and they look sort of like brass, not copper.  It may just be that they sat in a drawer for a decade or so and they tarnished.  So, in addition to them not fitting well, I'm not sure of their conductivity.
waterzlife
139 posts
 
Why not just biwire?  Better sound.
lak's avatar
Ag insider logo xs@2x
lak
4,623 posts
 
You might be surprised at the good sound one can achieve by purchasing copper wire (12 or 14 gauge) solid or stranded at your local HomeDepo or Lowes store and use that with bare wire terminal jumpers or buy some Duelund 16 gauge tinned - copper in cotton oil impregnated wire as jumpers.
mtrot OP
804 posts
 
@ waterzlife

Thanks.  Actually I ran these speakers bi-wired for years, but when I bought some new cables that were not bi-wire type, I found that the sound, including bass, was far superior.  The sound is so much better that I regret having bi-wired them for all those years.  Perhaps it's something to do with Legacy's crossover implementation in these speakers.

I'm currently connected to the HF terminals and jumping to the LF terminals.   The reason for that is that I want to get the best highs and mids, and considering that these jumpers are not very confidence inspiring, I want the cables directly connected to the HF terminals. 
twoleftears's avatar
twoleftears
5,318 posts
 
Assuming that one's working with a fixed budget, and assuming that there's not a very special crossover that requires bi-wiring, it seems to me that single wire + jumper of same wire makes the most sense.  I'd rather have one pair of $600 cables running to the speakers, rather than two pairs of $300 cables. 
More to discover