2. analog
  3. 1264563198

Technics SP10 MK3 bearing and lubrication

Does anyone know how to remove the spindle from an SP10 Mk3 so as to enable one to clean out the bearing lubricant and install new? This seemingly important topic is not mentioned in either the owners manual or service manual. (I don't have an owners manual, but I am assuming this is true, because none of the guys who do have a Mk3 owners manual can answer my question.) Any hints or relevant information would be appreciated. It seems certain that the process is much different from that of the Mk2. The usual suspects are just as much in the dark as I am on this question.
lewm
downunder
1,329 posts
 
Lewm.  You are lucky you are so close.   I am at the other end of the world :-)
lewm OP
13,436 posts
 
JP only requires the outboard box containing the PS and the drive circuit to do his upgrades, if that helps.  Since that box is so precious to the function of the Mk3, I considered driving it up to NYC and then picking it up afterwards.  It's about 240 miles from my house, and my sister lives on the UWS. (Upper West Side, to non-New York aficionados.)  But I think my level of paranoia is unwarranted.  Now that JP can fabricate the chip circuit, the PS can be considered to be replaceable if the worst should happen.
jpjones3318's avatar
jpjones3318
149 posts
 
Not replaceable; you’d be SOL.

I’ve left the world of the semi-retired, and now work 60+ hour weeks, so working on others ‘tables isn’t something I do often anymore - simply no time. 


More to discover