2. home-theater
  3. 1171989054

Problem with Arcam or JM LABS

I have an Arcam AVR 250 with an Arcam DV78. The speakers are JM Lab 716S Chorus Line(mains) w/ a JM Lab 700S Chorus Line (center) and JM Lab 716S (rears). The front 3 spkrs have Rega cables. The problem is understanding the dialogue from the center channel when watching movies. We think we have everything hooked up correctly and every setting set proberly. We have adjusted and readjusted every setting many times with little or no improvement. I have been running the mains on 0-5 with the center at 6 and the rears around 2-4. I purchased a sound level meter and set the levels correctly. No help. The voices coming from the center sound thick at times and slurred. We have tried the center at 5' and 2' with no improvement. The odd part is that I can understand every word coming from my TV during a broadcast when it is coming out of the center. Is there anything I can do to brighten the sound or is it just the British sound that I will have to learn to deal with. Thank you for your time.
kypride
jaybo
4,478 posts
 
sometimes its the discs themselves....there are no standards for ther multi channel mixes.....try the other audio options...mono, 2.0 etc
shadorne's avatar
Ag insider logo xs@2x
shadorne
7,477 posts
 
"Thick and slurred" is probably distortion somewhere rather than an incorrect volume setting. Perhaps an electronic problem with the center channel on the amp?
nealrm
68 posts
 
Sounds like a problem in the DV78. Check the audio output settings in the player and make sure that you are not "double processing". I have the AV8 and DV29 and had problems with cds because the player was trying to do surround processing on the stereo signal before sending it digitally to the AV8. It was apparenly trying to process cds like dvds. Volume would change randomly and voices were almost inaudibly quiet. Set the player so that it did no processing and cleared everything up. So, check the DV78 audio settings.
ryder
1,689 posts
 
Is there anything I can do to brighten the sound or is it just the British sound that I will have to learn to deal with

I don't know if your Arcam has the equalizer settings where you can adjust the treble, midrange and bass to suit your liking. My AV processor has this function. This will really help in your case if you find dialogues from the center somewhat unclear. Since you mentioned you have tried numerous times in adjusting every settings on the Arcam, I think this may not be of any help.

It's unlikely your center speaker would be faulty(you can always run simple tests on it) so I would guess the center channel of your Arcam may have some problem. Arcam gears being warm is no excuse for unclear dialogues from the center. Hence I share the same opinion as with Shardone.
kypride OP
18 posts
 
Here are a couple other points of interest that i did not mention about my system. The Arcan AVR 250 and DV 78 both sit in a pine entertainment center. The 250 is located above the 78 with a 1 inch hole drilled through the pine shelf for the cables to run through. The digital coaxial lead runs alongside the two analog interconnects through this hole. All three cables are made by Wasatch. Is it possible that the analog interconnects are causing distortion in the digital cable by being too close or are these cables just junk?
More to discover