Dedicated 20 amp lines/should i use a sub panel

@noromance/@lak,
Thanks for your feedback.
It seems like the hiss coming out of the speaker tweeter is a non-issue and in-reality that's not bothering me at the moment. So I would ignore it....
However turing off all lights/heaters/furnace etc is not going to be a realistic solution... Would a balance power transformer with its so much advertised common-mode-rejection functionality be able to  address the inconsistent A/V performance issue during day/evening? These items are expensive and relatively difficult to install, specially the units that connect to a 240V power supply. That's why I wanted to get an idea from this group before getting started on this project. For those who have this or similar power issue what do you do to avoid/eliminate it?
Thanks.

Hello Indranilsen,

The first thing I would do before deciding how to proceed would be obtain a multimeter, if you don't already have one, and measure the AC line voltage at various times of the day and night over the course of several days.

If you find that there is a correlation between the variations in sound quality and changes in line voltage, a power regenerator, such as one of those made by PS Audio, might be a solution. A regenerator is likely to also be helpful if noise or distortion on the AC line is contributing to the problem. On the other hand, though, some people have reported here over the years that in their systems some regenerators have resulted in compromised dynamics.

Also, in a thread several months ago you indicated that you were considering upgrading your Parasound Halo A-21 amplifier. If you haven't yet done that, I would suggest that you re-assess the situation after purchasing the new amplifier before deciding how to proceed. It's possible that a different (and presumably better) amplifier may be less sensitive to the power line anomalies at your location than the present amplifier.

Good luck. Regards,
-- Al
 

A balanced power transformer is most definitely an improvement and well worth it - I use them - one for my power amps and one for the front end.

The slight hiss you hear is generated by current running through resistors,  transistors and other components in your amplifiers - all electronic components have this to some degree.  Some resistors have lower noise than others, same goes for Transistors etc.  Its not something to worry about.

Good Listening

Peter

@Al- Yes, it makes sense to measure the voltage to narrow down the issue. I haven't upgraded the Parasound Halo-A21 amplifier because of two issues, room acoustics and power quality inconsistency issue that we are currently discussing. I have somewhat handled the room issue with GIK hybrid Alpha panels and wanted to ensure a good clean power feeding my music room before spending any money on the electronics. I have more or less decided to go with Pass Labs XA100.8 mono blocks when I am able to resolve these issues. 

@Peter- Is it worth spending $10K to get a branded transformer from Equitech or Torus instead of getting a Commercial Power isolation transformer at a much cheaper price?

Thank you all for responding to my queries.

So many responses, I apologize if this was already said:  make sure all lines come off the same side of your 220 line.