JAM by Duelund


Has anyone tried these new reasonably priced tinned copper caps from Duelund in any positions?

Cheers

S
shertzy
One thing guys for big values over 10 w the Munforf Supreme Resistors are very good. For tweeter- midrange  the most musical I have found Path Audio, ,and most certainly the most accurate out of of 12 ,not 1  even came to 1% variance and have a nice natural balance and depth far better then then even Duelund which mask s bit of detail even their cast very up to 10%,5%+, 5%-. And are $$ . Don't over look them 
I had the mundorf on the Voxativ driver, when the Path came in replaced  even without breakin  better everything especially depth,kidbass,low bass.
The engineer said 150 hours to fully runin, and they have a ground wire to ground 
For added quiet if needed.  For roughly $28 each  well worth the small investment.
Agreed on a Path Audio as they are quiet and even handed throughout the frequency spectrum.  . Best resistors I have used. I like the Mills MRA12 better than Mundorf, but both are good. Mills are nice and extended, but never bright.  
@audioman58  Extremely helpful feedback. My PAP Horn1 crossover came with 20.2 uf cap installed per channel. Here are the options you suggested so far:

1. Clarity Cap CSA (15 uf) + Cactus Blue (2.2 uf) + Jupiter Copper (3.3)
2. Jantzen Alumen Z cap ( 10 uf + 8.2 uf) + Dueland Jam (2.2 uf)
3. Jantzen Alumen Z cap (10 uf + 10 uf) + Dueland Silver Foil by pass cap

Option 1) is the most expensive. Option 2 and 3 is very close in price. Not sure what will sound better. What do you think about the following:

4. Jantzen Alumen Z cap (10 uf + 8.2 uf) + Cactus Blue (2.2 uf)

Option 4) is cheapest (only by a tiny bit).

btw, I ordered Path resistors to replace my Mundorf supremes in the crossover. However the Path resistors are 10W and going to replace Mundors 20W in PAP. Is that ok?
A 2.2 Jupiter Copper  and 18uf Jantze n is also a very good combo.
The bypass caps can all ways be added ,you have a Copper, or silver option 
Depending what you need more of . Silver for more top end, copper for more meat
On the bones.
 The path Audio are 10 watt . For horn Only . For woofers not as sensitive 
To critical midrange.  Write yo Chris , parts connexion tech support 
The munforf 20W  supreme is there for the big woofers If you want to improve them cut off rivets holding wire , get 18awg Neotech solid core wire 2- 4inches pieces solder where you cut . Much better. Stock are Nicole plated copper.