Reducing Background Noise On Records


Hello.  I'm looking into ways of reducing background noise on LP recordings. Some of my records just have a lot of noise (most likely from how they were recorded). My system consists of a Yamaha DSP-1A integrated amp, Pro-Ject Debut Carbon turntable (acrylic platter equipped) with an Ortofon 2M Blue Cartridge. My speakers consist of a pair of Wharfedale Rubiance RB-27's in the front and RB-23's in the rear with a Mirage FRX-S15 powered subwoofer.

I recently integrated a DVD 3BX-DS into my system to improve the impact and dynamic range of my records. Should this be sufficient or are there other devices (such as the KLH Burwen Research DNF 1201A Dynamic Noise Filter) that can better reduce the background noise of my records in question?  By the way, I do clean my records with a VPI HW16 record cleaning machine and rinse off the cleaning fluid twice with distilled water. I also use a Zerostat 3 to remove static before playing a record.

What do you think? 


128x128cspiegs
Assuming the cartridge is properly setup (if not get this fixed before anything else), culprits should be a dirty album which is solved by something like the Record Doctor V or similar, hum from your interconnects or dirty power which is harder to fix. I have dirty power and a good power conditioner helps but improving the ground at the circuit breaker and better wiring can be a big help. This could be pricey however.
I agree with 'Atmasphere"--also, total inertia of the revolving mass affects noise.  My Avid Diva 2 sp (15 lb platter) naturally has a pretty high background noise-only 12 mNm of torque, pretty small. I added Teres Audio 'verus' high torque drive system-somewhere close to 200mNm, and the noise all but disappeared.  I later upgraded from a Moon 5.3 phonostage to a Whest ps30rdt-special edition, and the background became BLACK. NO NOISE is not the same as actually hearing BLACK.
@cspiegs, When you have the Yamaha set to phone; but the tonearm is in it's rest do you hear noise? Is it a hiss or a hum? Have you had this issue since you got your TT/cart? Did you have it with a previous set-up?
Also, no matter what method one uses to wet clean LPs; the solution does matter. A lot. When I started using a solution of Triton x100, HepaStat, and alcohol my old LPs sounded much better. Better than using commercial solutions and LAST. 

@mattmiller & @gasbose , Good to hear that GruveGlide does the trick. I am not impressed with LAST and have been looking for a replacement for Sound Guard for decades.

As far as phono preamps go, I have gotten pretty "black" background on MM carts with a Schiit Mani ($129) and on MCs with an Emotiva XPS-1 ($180?); but the my integrated is very black to begin with. I've moved up to a Musical Surroundings Phonomena II; but I was not motivated by surface noise. @atmasphere , would you know if any of these have stopping resistors?