Duelund DCA16GA

I've been using the WE 16 gauge for a couple of years. I've recently added Tekton D.I.'s and a Had Inspire 7 watt SEP amp. Feeling I needed some more high frequency bloom, I purchased the DCA 16 and after about 34 hours of use it is a little more extended on top, but lacking some body and robustness in the lower regions. Today I just ordered the WE 10 gauge, but could not get enough for a double run.

So with that a couple of questions. Has anyone tried combining a WE, and a DCA for a double run, or is that a really dumb idea?

Since for now I can't get enough WE 10 for a double run, what about combining my 16 with the 10 being shipped this week for more extension on top?

And the last question I could use help with for now is with a double run on the D.I.'s binding post with no hole in the middle, and for me needing to use the posts, any ideas on best ways to terminate with a thicker bare wire on that type of post?

   LP

Get the Duelund 12 gauge and terminate with the Neotech solder-less connectors from Sonic Craft. Your 16 gauge needs another 80 hours of burn to fill out as an FYI.

@grannyring 
Bill, Is it your experience that the 12 gauge Duelund offers similar warmth, weight, and body of the WE, along with more air, and high frequency bloom?

BTW, thanks for the tip on the Neotech connectors.

   LP

Anybody try the WE interconnect? These is a seller for the WE on this site, who also sells the Belden IC... It sells for a bit over $200, but still reasonable as far as cables go. All of this IMO, of course... Cheers -Don