Classe Sigma SSP and Rel S3 connection issue

#1 Subwoofer Placement
#2 Rew and Sweeps to tell what the sub is actually doing in room
#3 Amp Gain and SSP LFE Level
#4 subwoofer delay
But everything is set small for me...
Center, surrounds at 60, 12db per octave

Oh and the test tones on the SSP are relative to the volume you have on the processor, you will want to be at 00 for level matching.

Then lets make sure the source is actually outputting 5.1 or 7.1 without downmixing, the processor does say 5.2.1 correct Dolby Digital or Truehd.... Not Pcm and the mode is set to discrete right.

What is the source feeding the system for movies and is it over optical, hdmi, coax, and is it set to bitstream out ?

I also I spoke to Ed from Svs, Give him an email as well if you have any questions on the sub / setup beyond my SSP tips.
emullen@svsound.com  

Hi thank u for your reply. I brought the Svs sb2000. Finally I got to the right setting and sub placement now. I set my front and center to 60 hz, surrounds at 80hz. LFE connect to Svs. Now the movie sounds a lot better than using the Rel S3 sub. I can’t believe it is almost day and night. The Rel is good with stereo music but no way for home theater. The Svs sb2000 is like $1200 cheaper than the Rel S3, and it is fantastic and with tight bass. I appreciate all your help, if u can give me a quick procedure on how to use the REQ, that would be wonderful. Thanks again.

I am in the same spot with my Ultra 13 have to make corrections, You will need a tripod and a good measurement microphone(About $100) or Radio Shack spl meter and Run an hdmi from your laptop, Get 00 measurements to measure an chirp with the SB, and a response chart, it will go thru a level calibration chart, And your microphone will come with calibration files for Roomeq wizard or a download for them(use them)... the .cal files)

Based on the impluse response sweep you can set the parametric EQ poiints in the SSP, and I would correct highest peaks, not  heavyhanded... In my config I don’t need a sub for music only for movies, you can run ssp configs for music and for movies and assign inputs to configs