This DNA-1 is setup for unbalanced inputs so the input impedance is 100K ohms. My current setup sounds really good, but I want to say there seems to be a very, very slight attenuation or just something missing in the neighborhood of 500 Hz. Perhaps that's just the signature B&K sound...it's not bad by any means, but if I had to put my finger on something, I would start there. Also the upper treble, mainly with the higher register of female vocals, it can sound slightly pitchy for lack of better terms.
It's hard to find the exact fault in my setup but for the sake of discussion, I would say I would like to smooth out the midrange and bring a tiny bit of warmth to the upper treble while maintaining detail and clarity.
Right now I have an Intenso feeding the Ref 50 then into the DNA-1. Instrument and vocal separation is excellent as well as vocal clarity...just seems to reach a little too high at times.
The Ref 50 does not have an analog pass through, "direct" mode I'm fairly sure it will still perform an analog-dig-analog conversion despite removing all tonal and Eq controls.
I agree $1500 is on the low side, but looking for an interim preamp until I can make a larger jump.
Hope that helps.
It's hard to find the exact fault in my setup but for the sake of discussion, I would say I would like to smooth out the midrange and bring a tiny bit of warmth to the upper treble while maintaining detail and clarity.
Right now I have an Intenso feeding the Ref 50 then into the DNA-1. Instrument and vocal separation is excellent as well as vocal clarity...just seems to reach a little too high at times.
The Ref 50 does not have an analog pass through, "direct" mode I'm fairly sure it will still perform an analog-dig-analog conversion despite removing all tonal and Eq controls.
I agree $1500 is on the low side, but looking for an interim preamp until I can make a larger jump.
Hope that helps.