Thanks again for proving my point.
I don’t need good luck though.
I don’t need good luck though.
Amps for KEF Blade 2
I am looking for advice from owners or dealers of the KEF Blade 2 loudspeakers. I am concerned my current pair of amps will not be sufficient for the B2s because of an article written about the original Blades published on July 5, 2013 in The Absolute Sound:
"The Blades have a nasty kick in their crossover that will suck an amplifier dry quicker than a student downing free tequila shots ... Just don’t be tempted to cheapskate on the driving amps, or you’ll live to regret it. Tube amps at least have an output transformer to hide behind, but when the Blades suck out a solid-state design, they celebrate by spotlighting their tweeter something chronic. To give you some idea of the lengths required, the otherwise excellent Rowland 625 [550 watts into 4 Ohms] wasn’t up to the job, it taking a pair of the 725 monoblocs [650 watts into 4 Ohms] to restore order. "
Are the Blade 2s just as demanding as the original Blades in terms of amplification? I would guess not due to the smaller 6.5 inch woofers, but this is just an uneducated guess. I own a pair of Benchmark AHB2 amps, which according to the manufacturer produce “a little over 500 watts into 4 Ohms”. Will this be enough?
"The Blades have a nasty kick in their crossover that will suck an amplifier dry quicker than a student downing free tequila shots ... Just don’t be tempted to cheapskate on the driving amps, or you’ll live to regret it. Tube amps at least have an output transformer to hide behind, but when the Blades suck out a solid-state design, they celebrate by spotlighting their tweeter something chronic. To give you some idea of the lengths required, the otherwise excellent Rowland 625 [550 watts into 4 Ohms] wasn’t up to the job, it taking a pair of the 725 monoblocs [650 watts into 4 Ohms] to restore order. "
Are the Blade 2s just as demanding as the original Blades in terms of amplification? I would guess not due to the smaller 6.5 inch woofers, but this is just an uneducated guess. I own a pair of Benchmark AHB2 amps, which according to the manufacturer produce “a little over 500 watts into 4 Ohms”. Will this be enough?
- ...
- 56 posts total
Wcfeil just read some of your responses. A forum is a place to exchange ideas on the topic at hand. Read all 7 of your responses almost everyone of them is off topic. In the future add a direct ancedotal story or raise a point that furthers the conversation I am quite sure most people are turned off by your immature drivel. Please tell people your direct experience with Kef Blades do you own a pair? We do. Dave and Troy Audio Doctor NJ |
KEF uses Electrocompaniet Nemo monoblocks to drive the Blades in their factory museum: https://www.youtube.com/watch?v=ZQBOMv4LY2E They might know a little something about driving them.... |
- 56 posts total