How do you think this AC power will be?

Just giving some updates as to my power cable build. 

I finally received my Sonar Quest end plugs. I made both of my amp power cables susing the DH Labs Red Wave 10guage cable and although it’s a very nicely made cable I like the bulkiness of the cable however I do not like how much stress I got to be on the inside of the end plugs. 

I almost fell its it’s to much wire. The other power wires I made are perfectly fine with how they fit and sit while plugged in. 

I haven’t had had much time to listen to my system since the cable change but I can’t say that it sounds better/worse but I doesn’t hurt to have the power cables or at least decent ones. I’ve rad that I may notice some improvements to equipment that doesn’t have larger more capable power supplies so that’s why I’m still going to make the one for my Bluesound Node 2 which is a different end plug than the IEC. 

This is is why I may just end up making willywonkas helix design. 

@williewonka 

I'm putting together my order for making your Helix power cables instead of using my DH Labs stuff. I have one question:

If I'm wanting to make two of them for my mono block power amps in 10 Gauge, should I just replace the live wire you have mentioned in your instruction site to 10 gauge? If you feel this is not necessary and I should just use the 12 gauge mil spec wire for everything then I will. 

@todd1010 - for your mono blocks...
- I would use a single 10 gauge Mil-Spec for the live
-  2 x 12 gauge Mil-Spec for the neutral (i.e. 9 Gauge combined total )
- 1 12 gauge Home depot wire for the ground

WRT the DH Labs cables you have made - they require about 60 hours burn-in before they even staret to sound better than theri initial perofrmance, but it does not get too much better - better dynamics.

If you used Sonar Quest plugs you should have heard better imaging from the start.

Hope That Helps