2. speakers
  3. 136713-101923

Integrated tube amplifier for large speakers

Hello,

Looking for some advice on Tubes and Floor standing Speakers.
Although I liked my system, now I am forced to upgrade my speakers (Bowers & Wilkins 705 monitors) and probably my Jolida JD 202 integrated tube amplifier due new room’s dimensions. I moved from a small space to a very large 950 sqft loft with 15 ft ceilings.
So I looked up for options within my budget and came across the following:

-Bowers & Wilkins CM9 (89 db Sesitivity) 8 Ohms Nominal Impedence. Recommended Amplifier:30-200w
-Focal Aria 926 (91.5 db Sesitivity) 8 Ohms Nominal Impedence. Recommended Amplifier: 40-250w
-Sonus Faber Venere 3.0 (90 db Sensitivity) 6 Ohms Nominal Impedence. Recommended Amplifier:40-300w

*I am aware that speakers’ impedance constantly fluctuates and that the newer B&W 700 series behaves more like 4 ohms, probably the CM series did to, but I am not sure how good small tube amps are at handling these impedences.

Jolida states that the JD 202 Integrate amp has a Rated Output Power of 40 W per channel at 8 ohms, 30Hz to 80KHz and a Maximum Power Output of 60 W per channel at 8 ohms, 1KHz.
Wrote Focal and they said it shouldn’t be a problem, but.....

Would this humble amp be able to run those speakers?
On paper it seems that it barely does.
I don’t listen to music at loud levels, however, I want to make sure I am not pushing the small amp to its limits.

How many watts per channel do you think are needed to power those large speakers and would you have any recommendations for integrated tube amplifier below $1500-2000 (used) ?

Your advise will be greatly appreciated,

Thank you,

Josep



mamifero
ctsooner
2,480 posts
 
Great tube choices for sure.  I have owned Quickies and loved them.  So well built and designed.  They also have an integrated amp now.  
mhart032
34 posts
 
I run a pair of Yamaha NS-1000s with a little Jolida Sj502a with Kt120s and vintage bugleboy imput stage. Sounds wonderful. That being said you can prob run just about anything you want with that amp. It can be had for less than a grand.

Edit: I do recommend changing the selection switch and pots out for better quality. Also beefing up the power board with better caps and resistors will help running the KT120s, but the 6550s run good too, if you choose to stay that route. 
kojak109's avatar
kojak109
2 posts
 
I would suggest a pair of Tannoy 15 inch monitor gold or hpd in lancaster cabinets or bigger and also as for the integrated I have been using a Korean Emille Ki-40l with a pair of hpd and is a good match. They fill my room which has 15 foot ceilings and is about 30 foot c 60 foot and reward you if you are sitting close at low volume or just mooching about doing stuff. (The Ki-40l is for sale at £2750 and is 240v) hope that helps. 
More to discover