2. pc-audio
  3. 133929-364

Aurender N100H Mods

The fact that Aurender runs Linux makes changing the system difficult but I have managed the following. 

Convert a 220v unit to 110v for US service and back the other way is relatively easy. A few wiring changes. 

Upgrade boot and SSD music cache from 120GB mSATA to faster and larger 256GB mSATA is possible but not for the novice. 

Upgrading 2TB HD to 4TB now. 2TB units have their 2nd drive pins omitted so to go larger you can’t add a second drive. Need to replace the smaller drive with a larger one.  Needs to be formatted or cloned to conform to Linux. 
fm540i
sprucewolf
1 posts
 
it'd be great if you could post tutorials somewhere and link them here, or write them here as posts. 
Post removed 
fm540i OP
47 posts
 
It’s been a while, I’ll need to pop the top off of mine. Have a swim meet to go too. Can it wait until later today?
First, confirm your wiring configuration.I remember the 220v version had 4 positions on the input side of the transformer. Going left to right I designate them wire position 1,2,3,4
If I recall there is a wire from the plug going to position 1 and 4. A jumper wire bridges positions 2 and 3
Correct?
fm540i OP
47 posts
 
Ok, the input at 220v has 4 wires. The din connector has 7 slots only 4 are actually wired. Slot 1 Black, Slot 7 White and a Bridge wire connecting slots 3 and 5. Correct? Looking from back going left to right on the Din connector. 

Transformer should be Amgis S8/L01-6371

Conversion to 115v. 

Black wire to Slot 3 ( looking from the back left to right)
White wire to Slot 7

The bridge wire is removed.  Only two connections. 
fm540i OP
47 posts
 
If msg me an email or phone number I’ll msg you a picture

More to discover