Top resistors

I have to say several tell me go with dpeciak brown ohmite ,carbon or micacomposit.
Even the Duelund Cast adds a bit of sonic signature. WILSON USE or did use caddock very neutral but lack a bit of nsturalness and depth . The path audio 
Given the proper Loong 150 hour+  was told to me by the engineers as well as owned for max detail and soundstage width,depth.  J documented and they were correct. The attached ground wire going to ground in crossover can make a difference ,all my capaciyors were measured and or outer foil documented 
With cactus symbol ,or line in Jupiter Copper foil.
Other caps must be tested on a scope,or noise meter. And without question 
Optimizes detail and super low noise floor. The Path resistors just complete 
The build, natural musicality end result.

I just replaced Mundorf Supremes with Path Audio resistors. Much better smoother sound with out the brightness that the Mundorf had.
But, I did not replace their legs with better wire as others have suggested.
Only complaint about the Path Audio is that the leads are very short.

ozzy

Pathaudio the best balance but over $27 each
the Mills mt12 I never have foundthem lean sounding after 75 hours 
with these Ar perry non. Inductive windings and special ceramic mix take time settling in .ido like the the fact silverplatedcaps, and leads Tinned Copper.sonicly 
mundorf Supreme mresist use nickel over copper then rivet leads, a bit harsh
i had to cut off and resolder with Neotech wire  much better balanced sound.
for the buck Millls mr12  a much trustedresistor at $4  ,if you  can’t afford the 
path Audio ,and don’t want to modify the legs on the big Mundorfs $16 each
same goes for the ohmlite gold with the rivets  very good but get rid ofthe rivets.
to get the most out of them.

Gents,
where can I buy Mills 5.1Ohm  MRA12 resistors in the lower 48 states? Only see MRA10. 
Much appreciated!

https://eu.mouser.com for big quantities

https://www.hificollective.co.uk/components/mills.html for small quantities