Ground Wires for Turntables

Right i read that manual but my problem is for some reason the spade connector is not there. So I'm wondering if i buy a ground wire individually would that sill work?

If the wire is there the simply strip it bare and tighten that down under the earth point on your amp. If there’s no wire then you could simply run a wire from the table (usually under a screw on the back say) to your amp ground but if you don’t have any issues without it then don’t bother. Five times out of ten in my systems cartridges sound better with the ground floating, every cart and phono stage will be different

The ground wire needs to originate from the tonearm tube, where it provides shielding for the phono cartridge leads right through the gimbal to the interconnect. It should be completely isolated from the rest of the turntable chassis (the motor and power supply).