Home theater crossover question

Like Kal said, the slope of the crossover is also important. That will take care of the 120 to 200 Hz range.

However. also like Javachip says, if your sub is crossed over that high, you're going to localize it. Even more problematic in my view is the fact that your crossover is is the audible mid-range for human voices, to which the ear is most sensitive.

You may not want to hear this, and you didn't ask in your thread, but I think you should seriously consider new front speakers if they have to be crossed over that high. There are many respectable, inexpensive, smaller speakers that don't have to be crossed over that high. There are too many problems that your settings will cause that will noticeably detract from the enjoyment of your HT.

Thanks for all the responses. My speakers are Infinity TSS-1100s (5 small 2-way speakers and the sub). Infinity recommends a subwoofer crossover setting of 120hz-150hz for the setup, so I reset all speakers to crossover at 120hz. Javachip and Kr4, the small speakers are rated at 125 watts and the self-powered sub at 250 watts, so I guess they can handle lower crossover settings. I may experiment with 80hz and see if it improves midrange response for CDs (2-channel system is off to listening room).

I think my original question has been answered; at 200hz for the front speakers and based on the sub's frequency response, I would lose part of the audio spectrum.

Yeah, what Kr4 said...

I looked at the specs for the Infinity TSS-1100 satellite/subwoofer system, and now I do agree with Kal. Leave the crossover for the front left and right speakers at 200 Hz, if that is what the receiver selected in the auto-configuration. The twin 3.5" woofers in each of the satellites are in danger of getting blown by excess bass energy, regardless of their rated power handling. Also leave the subwoofer crossover where the receiver selected, since as Kal points out, that only pertains to the bass re-directed from the satellites, not to the LFE channel. You will not be missing any part of the audio range.

To recap, the subwoofer will not be damaged by too high a crossover, although the sound quality may suffer. The satellites WILL be damaged by too low a crossover. Just place the subwoofer as close to the front satellites as possible (ideally right between them) and the subwoofer should sonically blend in with the satellites fairly well, especially since you indicate that you do your 2 channel music listening on a different system.

After digesting all of the advice, I compromised and set all crossovers to 150hz. Movies sound great and CDs sound about as good as I can get them to sound with this system, good enough for occasional listening. I still have my 2-channel system for dedicated CD listening. Thanks, everybody.