Perfect Path Technologies: Omega E mat

I misunderstood your words here...

”AND the inside of the chassis including the inside of the cover”

I suppose you meant the parts inside the chassis, but you can see it can be interpreted otherwise. 

Here is the warning that comes with Total Contact. The manufacturer is very active on this thread. Hopefully, if they have anything else to add they will.

IMPORTANT POINTS TO REMEMBER:

Perfect path Technologies Electrical Contact Enhancer is a next generation HIGHLY CONDUCTIVE contact enhancing formulation. If you bridge the gap between Hot (+) and Ground (-) with Total Contact you run the risk of damaging your equipment.

TO USE PAINT A THIN EVEN COAT on the MALE CONTACT SURFACES OR PINS ONLY! NEVER APPLY TOTAL CONTACT TO A FEMALE HOLE on any connector.

TOTAL CONTACT works on a micron level, do NOT OVERAPPLY!

TOTAL CONTACT can be carefully removed by using a clean cotton swab and pipe cleaner dipped in 90% or greater isopropyl rubbing alcohol….making sure Total Contact particles DO NOT get inside your component’s electrical circuitry.

sbayne ...

The key is to CAREFULLY apply Total Contact in a VERY thin layer using the brush included in the kit.

Not sure if you've seen or used the product at this point (have you?), but I can assure you that its NOT a liquid that is POURED over the inside of a component with irresponsible abandon. No one is advocating that. 

Thanks for your concern. Much appreciated.

Frank

candella007 ...

+1

The combination of the Omega E Mat and the Total Contact is the best improvement I've made in over 40 years in the hobby. That includes tons of tweaks in the past. Some had a beneficial effect, some did nothing at all. But the Mats and TC combined? Killer!

Frank