Power conditioner or outlet?


I have a Shunyata MPC-12a power conditioner. Read that it was a good choice for audio equipment so I bought it. I also have high end power cords to all my equipment, as well as to my Shunyata.

I have recently read comments from listeners that you should plug your amp/preamp straight into the wall. Is that the case if you have a good power conditioner? I will do so if it is a better option, just concerned about no surge protection for the amps...but also don't want degraded sound! I am asking this because I am a newbie at all this, more money than audio sense. I am interested if anyone might have any experience in this
128x128easola01
In my system I have my power amp and pre plugged into a Shunyata Hydra 2 conditioner which is passive and non current limiting with Shunyata Copperhead power cords.  Never ran out of gas.  
kalali

A good power conditioner will/should have no voltage drop with a high wattage hairdryer running with everything else plugged into it.
This is completely mistaken.

For one thing, it depends on the rating of the power conditioner. Many good power conditioners are intended for low current use. They simply aren’t designed to be used with "a high wattage hairdryer running with everything else plugged into it."

Moreover, a power conditioner can’t generate current. And it’s very common for sudden high-current demands to cause voltage drop - that’s a function of the service you’re receiving from the electric utility as well as other factors, such as the quality of connections in your service panel and your house wiring itself.

Some people assume that if they have "200 amp service" that the utility can deliver 200 amps, but nothing could be further from the truth. It means only that the service panel can safely distribute 200A. In practice, it’s common for the total available instantaneous current to be much less than the rating of the service panel itself.
n80
I’m aware that nothing is completely lightning proof from a direct hit but I suspect if I’d had anything in place between my TV etc and the wall outlet I might have saved my gear. How do you protect super expensive audio gear?
Something like these products can be very effective.
cleeds, perhaps my choice of the wording “good” power conditioner was subjective and not properly used. The power conditioner I use is an old 65 lbs. hospital grade transformer-based cube with eight outlets. It puts out a consistent 124 volts whereas the adjacent wall outlet is normally around 113-115 volts. I can’t claim it’s a “good” conditioner since I have not made fair comparisons but it continued to deliver the 124 volts even when I plugged in my wife’s hair dryer. I assumed, perhaps naively, that this was a sign of a good conditioner.
Edited to add that the conditioner is plugged into a dedicated 20 amp circuit.
Post removed