Home Theater Receiver recommendations for B&W 803S?

@bwguy 

I wouldn't use Airplay eventhough it is lossless Apple Airplay. 

@maritime51 - Thanks, though it looks like Darwin is quite a ways out of my price range...and I’ll need 5 of these cables. (yikes)

@caphill - Yep, thanks. I’m very excited to listen to the new system! Just have to wait for trucking from Canada... :)

At this point I’ll have to go with RCA interconnects because of the Denon, though I’ll probably want to upgrade to XLR once I replace the Denon. So it doesn’t make sense to spend a ton on these cables. I’m thinking of the Blue Jeans RCA’s - about $100 for a set of 5.
https://www.bluejeanscable.com/store/6channel/index.htm

As for racking, I need to go with something low and wide because of my TV and projection screen setup and space in the room. I currently have an HTM2, but am hoping to replace it with the larger HTM3S, so I need a good, wide shelf for it (that doesn’t interfere with the TV or the screen that drops down in the about the same plane).

Right now I’m toying with the idea of the Salamander Synergy 245... But instead of having the full-width top, getting single-column tops (on the taller cabinets left/right), and leaving the middle shelf open. Then my center speaker will have plenty of room to breathe, and my TV can straddle the shelf (the feet are on the sides).  It just... might...work...
https://www.salamanderdesigns.com/av-cabinets/synergy-model-245/

Congratulations!!!  I look forward to your results!!
----
You sure can do the Blue Jeans cables.  They are likely going to be better than the crap RCA cables that typically come with TVs and stuff.  But keep in mind these are also a compromise and will not allow your Denon/Rotel to "sing".  I tried some of the Blue Jean "Beldon" 1694A cables for interconnects.  They did have good resolution and authority, but the sound was just "meh" in emotional engagement.  There are so many better cables, but of course they cost more. lol.  Still, if you are doing this as a "temporary fix", it's still better than other alternatives.  One note on these cables - the LC-1 cable is a single solid-core 25awg conductor.  Great that it's solid-core (much better than stranded).  However, in my testing, the smaller awg conductors had good high frequency response, but just did not let the music "breathe" and they also had weak bass impact.  You really need to look for a minimum 21awg solid-core interconnect (which is what Audioquest are).
---
As far as the Salamander, I would say get whatever works.  But keep in mind that even though caphill says the Rotel amp does not get hot, you still need adequate ventilation above the amp and open space on the front and back of the amplifier.  When caphill says "the amp doesn't get hot", he really means that "it doesn't get roasting hot like a lot of high bias Class AB or full Class A amps".  The Rotel will still warm up some and it's always best to allow for heat dissipation.

Hahaha....yup...the Rotel does not get roasting hot even when driven hard. It barely gets warm to the touch. That's all.
But you still need some room ventilation around the amp. I wouldn't put it in a confined closed cabinet or rack if I were you. Ideally, it will be best placing it on an amplifier stand on the floor partly due to its weight and mass and size. 

Or, check out ac infinity fans.