Zerostat Milty really?

@skiro, I bought a NIB Zerostat on Ebay and it works, even lights up the test thingee.
Question... when you pull the trigger and release it slowly does it either make a clicking sound or feel like there is friction on the trigger?

If you do this procedure to your hand, can you feel any air blow out of the gun?

If so, the Zero is functional.

@skiroe and @lowrider57 may talk about a different issue. A functional Zerostat gun is capable of generating a certain amount positron, but not enough to zep the spark (a large amount of static). A large amount of static needs a very strong an-static device to neutralize it. I tried industrial anti-static blower and furutech destat II (https://www.youtube.com/watch?v=r4HAbC_WDHU). Even those device, it takes a while to neutralize the static. Please aware that the static is existing on both sides of the record. If only treat top side, you will still feel or hear the static when pulling the record from the platter. It also depends on when you apply the zerostatic shot, (i.e. before or after the static generated). You will feel not working if the static generated after applied shot. The source that generating static needs to be located even not easy.

@spincat, good point about static on the underside of the record. But does it affect sonics or tracking performance?

I doubt that static on the underside affects sound or tracking until you turn the LP over and play it. It's just that it compounds the problem when it is played. A fellow neurotic advised me to de-stat both sides and the mat before each play. I am not doing that! I'm not that bad yet; but it shows that we have a progressive disease.

The welding electrodes arrived yesterday and I played with them a bit. They definitely do something. They attract some things and repel others that are bound to a MoFi inner sleeve by static, but it takes quite a while to make them drop off. I don't think the rod over the LP while it's playing will work for me unless I let the record spin for 5 minutes before playing. I probably have a very static-filled environment, even though I humidify. However, leaving several rods on the mat for 15 minutes before a session seems to help. Normally after I play a side and lift the lid I immediately see dust being attracted to the LP. I saw almost none yesterday.

I'll keep experimenting and report any success.

@2channel8, it is good to know that the electrodes working well for you. The cartridge is such a sensitive device (measures from few milli-volts to sub-milli-volts). The static measures mostly from hundreds of volts. The typical thickness of record is from 1mm to 3mm. The impact is there. Most of the people do not hear the impact of static. They feel it because of the spark or pull from the platter. The impact on the cartridge is there even no spark or pull from the platter. It sounds degraded (edgy, fewer details, definition, extensions, etc). There is no turning back after heard how vinyl sounds without static. Just my experiences of dealing with static.

There are many reasons (recording, cartridge, arm, table setup) that some people do not hear the differences. This is also perfectly fine.