Running Benchmark AHB2 in bridged mode and 4 Ohm Speaker

@georgehifi Benchmark has no peer in controlling distortion , zero cross over distortion but without class A hassle. I will get answers regarding damping factor and total current. I am buying them used btw.

@kijanki thank you so much pointing fhat out. Will make sure to newer revisions. 

From the review: 

"So, what about that comparison of cables between the Benchmark and Clarity sets? I set up the following components and rotated sets of cables between them: Salk Audio StreamPlayer III, DAC3 DX, AHB2 Amp (two in Mono mode), and PureAudioProject Trio15 PAP Horn 1 Speaker. "

and 

"Again, the four components in question were the DAC3 DX, AHB2 Amplifier (2)"  

I think the typical reader would understand that "(2)" meant used in Mono mode, as I had been doing earlier. 

It’s clear that you Benchmark bridging "experts" have no idea what happens to a stereo amp electronically when it’s bridged.

Guarantee whoever spends the bucks and does it here, will be back asking for other alternatives after they lived with their bridged amps.
When they’ve realized it was a backward step from using the same amp non bridged, even though it didn’t have the watts to go loud enough.
And they’ve realized all they gained was watts, and everything else sound quality wise took a hit.

Cheers George

@kijanki My amps manual says the same i.e 29A peak into 1 Ohm. Is this per channel I am assuming?. Most amp state this number per channel if I understand that right.

@kijanki never mind the website does mention 
"MAXIMUM AUDIO OUTPUT CURRENT

• 29 A peak, per channel, both channels driven"