Thiel cs2.4 upgrade to cs 2.4 se

Hi guys, 

I just realised that there are two versions of claritycap csa i.e 250v and 630v. I have ordered 250v version. Is there any concerned and or any sonic difference?

For beetlemania,

From the thiel owner thread, you have changed all the ceramics resistors to Mills resistors and gained vast improvement. Nevertheless,  I noticed all the original ceramic resistors are rated 10w but Mills MRA12 are rated 12w. Is there any particular reasons that you changed the spec?

630 V version has thicker film. Tom Thiel (and his sources) is confident that will sound better. We are putting 630 V on the coax feed (ie, 14 and 28 uF caps) for maximum SQ. Where you are runnng in parallel to get proper capacitance, you might use a 250 V for the heavy lifting and 630 V for the final icing on the cake. Eg, 25 uF 250V plus 3 uF 630 V for 28 uF cap. The 43 uF subfeed cap is downstream from a 16 ohm resistor and will be a 250 V CSA. Elsewhere, I will be using 250 or 160 V caps, except for the Multicap bypasses which are 600 V.

That said, have fun and please relax about getting this “right”. CSA 250s are certainly going to be a notable upgrade over the OEM caps!

MRA-12 will give you more headroom compared to the OEM 10 W resistors. That is good!

Beetlemania, thank you for the wonderful information.

Dear holco and beetlemania,
I tried to remove the radiator but unsucessful. The radiator is still stuck with the enclosure. As adviced by holco, i shall remove the radiator by push it through one of the screw hole. Shall i push much harder through the screw hole by a smaller screw driver or there is other alternative. I'm worried that i might damage the radiator. Your help is much appreciated.