- ...
- 174 posts total
The final components choice for the CS-2.4 crossover upgrade, it will be made on new larger Jantzen Universal PCB's and soldered with Jantzen Solder, 4% silver https://www1.picturepush.com/photo/a/16092231/1024/Thiel-CS-2.4/CS-2.4-SE-final.png |
@holco curious why you’re putting a foil coil on the woofer board and not replacing the one in the coax feed (0.15 uF). One caution for the DIY crowd from Tom Thiel is to pay attention to the DC resistance on the boards as new parts can change these values and upset the balance. In my case, the new parts matched original values within 0.1 ohm. As Tom’s beta tester, I have full value capacitance in single caps. Only my bypass caps (~1% Multicap RTX) are in parallel, but those did not add measurable resistance. |
On my boards, that coax feed coil is an ERSE FoilQ. It is availble in 16 gauge at 0.15 mH. The OEM aircore one is 18 ga but I cannot tell it hurt anything to increase the gauge and was OKed by Tom Thiel. Then again, I’ve changed so many parts at once that it is near impossible to say where the biggest improvements came from. Well, I did change the resistors to Mills as a first step, so I know what those add to SQ. I will soon compare the Clarity CSAs with and without bypasses on the coax feed. |
- 174 posts total