Bi-Wire with two pairs of speaker cables


Stupid question:

My speakers have dual binding posts, so they can be biwired. Want to try. Currently using single wire speakers with jumpers.

So instead of selling current speaker wire, and buying new biwire set, can I get a second set of single speaker wire, identical to what I have, and run them from my Amp to the second set of binding posts on my speakers? Of course, removing the jumpers. I think I have enough space on Amp to fit a second set of spades
128x128thyname
I hear you, jl35. The few times I tried biwiring it did make an improvement but nowhere near as much as simply spending the money on upgrading to a better single run cable. I mean it was not even close. That was many years ago, so given how far cables have come I'm sure its the same today only even more lopsided in favor of the one good cable. Has anyone bothered to make that comparison?
External bi-wire if you can with 2-4” of separation in the long runs... the science is the LF field modulates the HF
the field strengydrops dramatically w distance
this is why many internally biwire cables don’t sound better
....
Agree with Tomic.  Forget the internal biwire cables. They defeat the main benefit of biwiring.
Bollocks! When will audiophiles realize that changes they make to their system is specific to their system only?!?!?!

The reason for BiWiring is to stop woofer current from modulating tweeter current.

It is totally permissible to use two different cables.

Each and every combination will have various effects.
Jumping one of the legs at the speaker will sound different on every speaker.
Separating the cables will change the inductance and thus the sound. I like mine interwoven.
There is no need to have dual amp outputs, two spades on one terminal or two leads into one spaded is fine. Adding a second terminal adds additional LCR which may or may not alter the sound depending on the components chosen.

In ALL cases, audibility is program, system and listener dependent.

Ignore fan-boy recommendations, experiment and keep what sounds best to you.

Please see http://ielogical.com/Audio/CableSnakeOil.php/#BiWire for a BiWire analysis.
Bi wiring a tube amp is very effective when you have 0 - 4 - 8 - 16 ohm connections. Use the "4" as "common" and the "0" for woofer, and the "16" for the tweeter. Polarity of the tweeter may have to be reversed. Easy enough.
Now the thinner (usually) 16 ohm wire inside the transformer only carries the tweeter current. Thinner wire has better skin effect properties for higher frequencies too.
The voltage on 0-4 and 4-16 pairs are the same but phase is opposite with 4 as neutral. 8 has lower voltage, which can be OK is the tweeter is "hot" and you want to lower it.
Try it. Nothing bad will happen.