Thiel cs2.4 upgrade to cs 2.4 se

The second board measure also 30.1 ohm, so atleast they are exactly  the same, think that it is the Jantzen Cross coil, 0.12 ohm vs the 0.3 ohm on the original air-coil.

Probably a question for Tom Thiel . . . I do know for individual components +/- 3-5% is acceptable, but maybe the tolerance is tighter for the global circuit? As a check, l compared the frequency response of a tone glide with and without the upgrade (well, OEM boards with resistors replaced). All good in my case. If the balance sounds right, you’re probably good. If you’re paranoid, ask Tom on the other thread. He *might* recommend modifying a resistor value.

Finished the second loudspeaker and there seems nothing wrong, except my jaw is on the floor, what a great great great sound!!!

@holco 
yes, I literally had a grin on my face after I had the second channel upgraded. I was able to hear the improvements in mono but going to stereo put me in musical bliss. Wow!

Dear beetlemania,
I'm comtemplating to  upgrade the resistors in my xover suggested by you. May i know is there any sonic difference between the old millls resistor vs vishay mills resistor?  Which one sounds better? 

Dear holco,
Can you share some videos or thoughts  after the major upgrade?