DeoxIT on tube pins


I remember reading that this is not to be done & only a comprehensive clean using fine grit paper.

What's the general consensus?

Thanks 
Rich
128x128infection
I agree that one should not use excessive amounts of any enhancer.  Nor should one repeat the treatment over and over again. I have read warnings about using Walker SST on tube pins, because of the heat issue raised by Elizabeth.  But is there real evidence that ProGold bakes on and forms a non-conductive goop?  First of all, it seems to be a fairly dilute liquid.  Just the act of installing the tube after a single treatment, even assuming one does not wipe off the excess liquid a priori, would tend to re-distribute the suspension (or the solution) such that there is mostly metal to metal contact between pin and socket.
Has anyone tried to clean enhancers from tube sockets? Tube sockets get hot. Really Hot!
The main problem you see is contact enhancer getting onto the top surface of the socket, after it I squeezed out when the tube is inserted after too much enhancer was applied. Where it can possibly cause a short. The top of the socket should be cleaned if necessary.
Another option...regarding magic eraser....the substance/product that florists use in their arrangements??