heeeelp please audio reserch 5SE - resistor blew up


hello
i just installed a 6550 in my audio research 5SE and one resistor blew up  just underneath the V5 tube and between the 6h30 smaller tube.on the left there is a black resistor


thank you very very much
view63
IF you can’t hear the difference a NOS Tung Sol make in the power supply of a REF5se you need to upgrade your system, your hearing or both
stop by Seattle and we can swap in 4 nice NOS or the factory tube see how ya do......

enjoy the music.....
I also trust Andy to test NOS regulators and rectifiers. Using Tung Sol in two Audio Note components. T-S recommended by the designer.
But let’s ignore all that and focus on REF 5se or any other tube preamp above let’s say $10 K

invest in a spare set of tubes, Factory if you desire
and a decent tube tester

both of which pale in comparison to your initial investment.....

and DHL services most of the planet, why not get that 6550 tested or replaced before installation?


Yea some people can hear the difference in regulator tubes.  I can't and you need not show me.  We are all here to try to help the OP revive his line stage.  I have had it repairing gear that's been "NOSed" by snake oil merchants.  Audio Research, Sonic Frontiers, you name it.  But too many people just get talked back into it after and after a month or two they call me again.
hey guys

thank you all
i found my problem on the 5SE , there where 4 zener diode on the other side of the board that was open .
after replacing them the pre amp works.
i have a question  for you , i found that when i swutch from balance to rca , and there is no rca interconnect is plug in i can ear music that is very low . is that ok ?
and another thing , i put a new set of 6h30 and 6550 from sovtek
and the sound is bad , does the tubes in break in before it start to sound right
thank you