Question About Audio Research Preamp Specs

Yeah, that’s >33x more, I see no reason why they would state that. Hell, even 8x is debated as the recommended minimum.

You're reading it right and your 10 to 15 x is generally accepted. The world will not stop rotating if you use a 10k load.

I think where this goes is that the preamp may not meet full specs if you feed it into a 10k load. Output voltage may be compromised, THD may be a little higher and low frequency rolloff may be earlier. It will probably be fine and not hurt the preamp but may not sound the same in your system as in another one.

The Sterophile reviews for most of the ARC preamps I've seen seem to recommend a minimum of 10K in the test section, biggest concern being low frequency roll off. I've been feeding ARC preamps into 15K for years and they all sounded fine (Ref 2, LS26, LS 25).

I’d recommend against it. I have an LS-28 and a Rogue Stereo 100 which has 200k input impedance and this combination works well.  However I once tried to run a subwoofer with a 10k line level input impedance in parallel (causing the LS-28 to effectively see about 9.5k) and the neither the LS-28 nor the Rogue liked it a bit. Sound was distorted and the power tubes glowed red. The ARC recommendation of a minimum 20k load appears to be there for a reason.