Connecting a subwoofer.....

Thomas, does your sub have "speaker in" and "speaker out" binding posts? If so, you can just connect speaker cables from the same binding posts you hook your speakers to on the Naim Nait... to the "speaker in" (don't worry about "speaker out") and that way have high level connection like you would with a REL.

The sub can be connected using a rca cable from the amp/recvr sub out which would be line level...or run speaker cables to the sub as if they were the main spkrs...and then more spkr cable from sub to spkrs themselves. That would be speaker level. There is no right or wrong way but rather an ideal way based on your ability or there lack of to control the xover freq. Your amp may or may not have xover freq control...chances are it does not if it's a stereo amp therefor you will want to engage/turn on the subs xover switch and use dial to blend mains with the sub. Say you are using some monitors that are capable of 55-60hz lowend...set sub xover at or about that freq so it takes over where the monitors ign off so that there is a smooth transition. I think this is what you are inquiring...I think.

Thanks a lot so far guys. I was starting to think that maybe I couldn't use a sub with my set-up. Problem is, I have my gear in another country where I am going. If I had it here I am sure I could figure it out. I just want to make sure I have the right/enough cables to bring with me since I have to have a sub with my music. Anyway, due to your help things are looking promising - thanks again.