2. home-theater
  3. 1274585428

Signs of poor electricity in home...?

Ok folks I know pretty much that all homes have crappy power for electronic gear. However my dilemna is that I have continued to have a buzz type sound come from my spkrs whenever amp is powered on. This is the same case with three different amps and a recvr. I just completely disconnected everything and have all the gear everywhere in the living room. This was no small task.
Nht Controller
Nht Power 5
Nht Power 2
Oppo 83
Toshi HDDvd
AudioControl Bijou EQ
Panamax 5500ex
Nht A1 x 2 for bi-amping mains.
Nht X2

I use Signal pwr cables and my own custom made.
Signal, Bluejeans, monster ic's
PS Audio powerport

I have eliminated any cable combo as the culprit and have it narrowed down to the fact that with an amp plugged in, powered on, and just spkr cable connected to a spkr I get this slight buzz/hiss type noise. I mean nothing connectected to amp but what I said...electricity...and spkr cable direct to spkr. It is not the hmmmmmmmm of 60hz...it's a hiss like white noise makes when a tv channel would sign off-air if you are old enough to know what I mean. Anywho...it's bugging me to pieces. I have went to the breaker box in garage and eliminated it being the fridge in neighboring room, etc. Even with the Panamax it still gets noise to the spkrs mid/twtr...mainly mid. Volume has little or no effect on it if you are wondering.

So????? Dirty house power and what do I do. Would having a seperate/dedicated line help? I don't have dimmer lamps or any other of the typical buggers in the ac chain. No tv either as I have a Pj setup which plugs in where I use to have a ceiling fan and installed box/receptacle to pwr it.

I don't hear it if source is playing but sitting idle all 5 spkrs doing this is annoying. Suggestions please.
mnnc
mnnc OP
175 posts
 
Hifihvn...interesting ideas. I will try some of your sugg...however, the loose connections in brkr box...forget it unless I kill pwr from outside main and then what do I tighten? When I look inside brkr box all I see is brkrs sticking out and ON or OFF. Where are the connection screws? Our pwr feeds are underground type. I could call pwr provider and have them do a chk/service if it's at no charge to me...pardon the pun. Thanks.

JJones...what would foil do or more important what would it prove? Again, excuse my ignorance, what would the plugging lamp into same plug/receptacle prove? What am I looking for during experiment/troubleshooting? Thank you too.
detredwings
162 posts
 
This may sound odd but I had this problem before.
I had AC riding on the ground. Try using one of
those cheater plugs. Three prongs to two prongs.
If you plug in the power cord into the cheater
plug and the problem goes away you can then look
into the grounding issue. It only takes a couple
minutes to try and costs nothing. Good luck
mnnc OP
175 posts
 
So a 'cheater' plug is one of those adaptors that has 3 female/2 male...? Basically eliminating use of the gnd pin being plugged in? Will this not hurt my gear? Not all the amps/recvr I have are being used at same time and a couple of them differ in design concerning having 2 prongs in their iec or 3 prongs. This is by the nature of the manufacturers design. All gear is US 120v.
mlsstl
1,475 posts
 
Try to define the problem a bit more. You indicate this is not an AC buzz, but rather a white noise hiss from the mids/tweeters.

Is this audible from the listening position or do you have to put your ear to the speaker?

All electronics produce white noise but it is usually very low in level and inaudible at the listening position.

Do you have an usually efficient set of speakers? This could have nothing to do with your home's AC power but rather a mismatch between the gain of the amp and the speakers. If it's not audible at your listening position, I personally wouldn't worry about it much.
mnnc OP
175 posts
 
Well, I'm not sure if it's an ac buzz as I 'm not really sure what an ac buzz is. I am figuring that based on other users of the same gear report no noise/buzz/hiss. The noise is slightly audible from main listening position @ 11ft. in a moderately quiet room and clearly audible as you approach the spkrs closer. Particularly from middle channel which produces the most. The best way to describe the noise is it's a whining hiss...like you might have in a car audio system when alternator buzz is heard through the spkrs...just not as pronounced. The mains are 87 or 88db rating at nominal 6ohm. All spkrs are Nht Classic series.
More to discover