The stock Dk 300 Denon plinth is bad ?
Plinth ideas for DENON PD-80 DD turntable
While my pair of Victor TT-101 still sleeping in the storage, i decided to buy another Flying Saucer.
The DENON DP-80, vintageknob always have nice images and info about rare stuff...
On that page you see DP-80 with DA-401 tonearm for hich compliance cartridges (i have this tonesm NOS). It could be an interesting project, it was hard to resist ...
The question is the Plinth for this Denon DP-80.
The original DK-300 plinth is an option, but searching for something better i found this one.
Custom made plinth is always an option and i have superb Audio-Technica AT-616 pneumatic insulators to use under the plinth.
But what do you guys using with your Denon PD-80 ?
P.S. some companies now producing even an iron cast plinth and graphite plinth, i have no access to graphite, but iron cast here is cheap to make a custom plinth.
The DENON DP-80, vintageknob always have nice images and info about rare stuff...
On that page you see DP-80 with DA-401 tonearm for hich compliance cartridges (i have this tonesm NOS). It could be an interesting project, it was hard to resist ...
The question is the Plinth for this Denon DP-80.
The original DK-300 plinth is an option, but searching for something better i found this one.
Custom made plinth is always an option and i have superb Audio-Technica AT-616 pneumatic insulators to use under the plinth.
But what do you guys using with your Denon PD-80 ?
P.S. some companies now producing even an iron cast plinth and graphite plinth, i have no access to graphite, but iron cast here is cheap to make a custom plinth.
- ...
- 75 posts total
The plinth is solid. Well made but the feet is the weak spot there. Poorly executed. The feet on the DK300 can be upgraded to Stillpoints or equivalent. I was going to do it but it sold before I had the chance to do it. It’s basically a little plastic piece with a threaded stud screwed on to the plinth with small wood screws and the feet screws on to the stud. |
@genesis168 The plinth is solid. Well made but the feet is the weak spot there. Poorly executed. The feet on the DK300 can be upgraded to Stillpoints or equivalent. I have my AT616 pneumatic feet, so i am well prepared to replace feet under any turntable. It's a good news that stock DK300 plinth is good, maybe i have to buy DK300 first. |
- 75 posts total