Best amp for Wilson sasha DAW


Just received my new Wilson Sasha DAW speakers and am now beginning to sift through a long list of electronics that would bring out the best in them. If anyone owns these and could give some recommendations I love to hear them. I’m open to tube or solid state. Looking for amps and preamp. All opinions are appreciated.
128x128Ag insider logo xs@2xcarey1110
VTL, Audio Research Reference, Pass XA .8, Boulder, D'Agostino, Spectral, with 20k you have a really broad spectrum of possibilities...
Seems like there is a lot of knowledge in this thread.  If I already have two Nagra MSA's, would those be sufficient in mono to power the Wilson DAW's?
carey1110 OP

They are efficient at 91db so a 100w into 8ohm amp will do, but! looking at the mid bass area where all the grunt is needed, this 2.4ohm impedance load combined also with 45 degrees -phase angle loading around that area. https://ibb.co/Xx3TdXr means they are going to be a "current suckers".

You should be looking at amps that will remain stable and with good current ability down to 2ohms. T
Ones that can double that 100w to 200w into 4 and at least 300-350w onto 2ohms, good solid state linear amps will do this for you, and this will then give the very best from the bass of the Sasha DAW’s

Cheers George