Revel ultima 2 salon owners biwire or not


How many of you are biwiring your salon2's
Do you find it to make a noticeable difference
I am awaiting a pair of the salon2 soon
My system
Basis 2200 signature with vector4
Aesthetix Rhea signature
Ayre c5xe
Parasound jc1
Bat 51se
Speaker cables kubala emotion non biwire

B
Thanks
Raghu
rdasari
Rd,

I am very impressed with the Salon2 so far with just single wire. I would just start with single wire. I may try bi-wire later on but I don't expect much improvement if any at all.

I think you will like the Salon2s.
Sfstereo
My pair should be arriving in the next 10 days or so
I can't wait
I will try single also and see how things sound
Rd
I just purchased a pair of Studio 2's. With my speaker wire if I use the upper, "HF", binding posts I cannot get the door to shut and lock. The door has a lip on the inside. With the lip, there simply isn't enough room for the wires to fit inside the depression, below the lower binding posts, allowing the door to shut.

I took the doors off which appears to be one solution. The other is to cut off the center portion of lip that interferes with the wires. With this design using banana plugs would appear impossible, as would bi-wiring unless one used very thin wire.

I was wondering what you other owners are doing?
I agree, using banana plugs with the door closed seems impossible with these speakers. That was very annoying, because my preferred connector is a locking banana. It sounds like your problem with the upper binding posts is that you are using a thick or inflexible speaker cable. If you want the door to close and you want to biwire you must use a very flexible wire, like zipcord (which I use). If you must use a high-end speaker cable you must open/remove the door, or just use a single wire.
Frankly, the doors are at the back of the speakers. The fact that they are often open doesn’t bother me in the least - wait, do you think that the doors being open has an effect on sound quality?