Our OTLs do a nice job on the Alexia, Sophia and the like and they don't do anything like doubling power. The Wilsons are fairly easy to drive so most any solid state amp will be fine with them.
- ...
- 420 posts total
Our OTLs do a nice job on the Alexia, You’ve now got to be joking!!, out of courtesy I didn’t mention which OTL’s wouldn’t drive these 89db JBL’s 1400’s, but now you leave me no option, they were a pair of your M60’s!!!!! and now your saying they’ll do a nice job on Wilson Alexia!!! ???? Probably the hardest speaker know to man to drive. This is just getting too ridiculous for words https://forum.audiogon.com/posts/1803629 https://forum.audiogon.com/posts/1804702 |
@viber6 - no need to get defensive about your Mytek Brooklyn amp. No where did I mention anything about quality of sound from any amp. My comments were specific to mcreyn's question to George. I would also like to add, my post has everything to do with the question asked about Class-D amps for 2 ohm speakers (from the OP), as the Manufacture specs do not align with the measurements from Stereophile. And I'll repeat it again, 'this is George's point about Class-D amps not being suitable for low impedance speakers - make sure they measure as the specs suggest because more often than not, Stereophile mentions the amp will have a hard time with low impedance speakers." Please don't twist my words around again and make this into something it isn't. |
golfnutz, In my post, I was not defensive about my Mytek Brooklyn amp. I thanked you for quoting Stereophile measurements whose power capabilities are at odds with the excellent sound quality described in the review and confirmed by my listening. My "SO WHAT" comment was intended to refute George who holds up the Levinson ML2 as the paragon of excellence for technical specs. The truth is that it sounds like muddy molasses at any SPL despite its power specs. But George has never heard it, doesn't care to listen, and merely goes on and on about irrelevant technical subjects. As to your point about the usefulness of independent measurements, I agree. |
You’ve now got to be joking!!, out of courtesy I didn’t mention which OTL’s wouldn’t drive these 89db JBL’s 1400’s, but now you leave me no option, they were a pair of your M60’s!!!!! and now your saying they’ll do a nice job on Wilson Alexia!!!MA-1s. Not joking- Wilsons have always been fairly efficient despite their impedance. They seemed to sound just fine to me. They played loud enough too but it was a smaller room IME. We also noted that particular customer was going through power tubes faster, which is no surprise since a lower impedance will cause more of the power generated by the output section to be dissipated in the output section- and that's hard on tubes. We finally got him to install a pair of ZEROs and then the tubes stopped failing, plus he had more power. The Wilsons traditionally have been fairly efficient so none of this should come as any surprise. The national sales manager at Wilson (John Giolas) had our amps for several years. |
- 420 posts total