Oppo 95 with DVDO iScan Duo


To avoid using an HDMI switch I'd like to take the HDMI output of my Oppo 95 through my DVDO iScan Duo to my Cary Cinema 11a. The video from the Cary goes directly to a Sony VPL-50 projecting onto a 100" screen. Are there any known problems with such a link? The iScan Duo is currently handling only output from a DirecTV HD-DVR.

IIRC, the iScan Duo can pass DSD audio, although I use balanced analog stereo and 7.1 analog audio from the Oppo to Cary inputs set to bypass.
dbphd
Hevac1 asks, "What SW version do you have in the iScan BTW."

I don't know, but I've been thinking about trying to do an update. The problem is should I run into a glitch in a download, past experience suggests DVDO support will not be available to help.

In support of Dan Wemmer's (Cary) hypothesis of an HDCP handshake issue with longer HDMI cable, A/V was fine with short cable to monitor, but same setup failed with cable to ceiling mounted projector. Lumagen extender is scheduled for delivery the 30th. Until then, I'll try to shorten the cable and connect to the projector from the Cary 11a rather than the iScan Duo.

db
With my iScan duo the HDMI input cables are all 6'. I have 2 Oppo's the 83 & the 95, computer and dish network. On the output I have a 50' to a JVC projector and a 25' to a Panasonic GT monitor. All works well together here.
Hevac1,

I don't have an explanation for the problems I'm having. There are only two reversions to the setup that worked flawlessly for several years that I haven't tried: (1) disconnecting the Sony from HDMI-1 of the Cary and reconnecting the Oppo 95, and (2) replacing the 1.5 m AQ Carbon HDMI cable with 1.5 m AQ Cinnamon. I had woriied that I may have damaged something by switching HDMI cable around while the components were in standby, but all seemed well when the output of the iScan Duo was connected by short cable to the monitor. I'm frustrated.

db
I know how frustrating it can be as I went through most of what you are running into also. I do remember have issues when I first purchased the iScan but the sw upgrade took care of some of my issues. I also had to reset my unit a few time because of setting things up on the outputs incorrectly. So try to reset your iScan back to factory default then go from there, as this will reset any settings you may have done wrong or forgot you did in the first place. I am in Mass BTW where are you located? I think if you cycle power the front display will show SW version or just bring it up info on your screen. I will look at mine to find the version I have.
I am in Mass BTW where are you located?
Montecito, adjacent to Santa Barbara, CA