dan, possibly you got that result, because a 10-ohm load resistance would result in a very severe high frequency roll off in the audible range, using almost any cartridge except maybe a very LOMC with a 2-ohm or lower internal resistance. You threw out the baby with the bathwater, as the saying goes. "Hiss" is probably at about 2kHz or higher frequencies, usually.
Phono Cart Impedance Question
I have a little bit of hiss through my 6 ohm, 0.28mV cart but only at a volume pushing the upper end of my listening volume...and it's only audible before I drop the needle, and even then not from the listening position. I realize I therefore likely have a "non problem"!
But I still have a generic question on to the sensitivity of producing hiss as it relates to cartridge impedance alone. If one kept all other cart specs identical (including output of course) would you expect hiss to go up or down at the same volume and system gain if I used an 8 ohm or 12 ohm cart instead? It seems like the hiss would likely go up just like moving to a higher impedance speaker under the same gain setup but perhaps I'm looking at this incorrectly? I realize moving to a slightly output cart could very well reduce the hiss.
Thoughts? Sorry if this is a ridiculously obvious question and answer.
But I still have a generic question on to the sensitivity of producing hiss as it relates to cartridge impedance alone. If one kept all other cart specs identical (including output of course) would you expect hiss to go up or down at the same volume and system gain if I used an 8 ohm or 12 ohm cart instead? It seems like the hiss would likely go up just like moving to a higher impedance speaker under the same gain setup but perhaps I'm looking at this incorrectly? I realize moving to a slightly output cart could very well reduce the hiss.
Thoughts? Sorry if this is a ridiculously obvious question and answer.
- ...
- 45 posts total
- 45 posts total