2. speakers
  3. 152074-129255

Bulding Cabinets, Binding Posts, and Speaker Wire ???

I am building a pair of boxes for a 15in fullrange driver. I have 2 pairs of audioquest rocket 88. 1 pair is 10 feet. The second pair is 8ft. I was going to use the 8ft pair as the cables for inside the box. These would run from the driver to binding posts. The cables are connected with spade connectors. Obviously connectors could be removed, but have never attempt anything like that and do not want to ruin the cables. Are there any quality binding post that can accept spade from the inside of the box? If not, any good recommendations for binding posts that dont need soldered. Also, if anyone thinks this should not be done for any reason(to long of cable run), please chime in. 
akwilson501
imhififan's avatar
imhififan
2,176 posts
 
http://www.cardas.com/images/ccgr_l_drawing.jpg

You can use an additional 5/16"x32 nut to fasten the spade connector from the inside of the box.
How about the driver side? Don’t you need to solder it to the driver?
imhififan's avatar
imhififan
2,176 posts
 
BTW, a GOOD mechanical connection is as good as a GOOD soldered connection.
akwilson501 OP
50 posts
 
Thanks for the advice everyone. I will be cutting the cable down. The driver will be connected with the spade terminals, as it is easy to do. I will either crimp or solder the other side of the cable to the binding posts. It’s just 1 15in full range driver per box, no crossover or anything. Both boxes are 15in deep, 19in wide, and 44in tall, if anyone is intrested. Simple bass reflex cabinets.
More to discover